OSHA Inspection: HAUSMAN PLUMBING, INC.

Issued

Jan 10, 2019

Penalty

Initial $4,434 · Current $5,174

General-duty citation text

29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502.  Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems.    On January 7, 2019 located on the south side of a residential roof, an employee was exposed to a fall hazard while installing a vent pipe flashing onto a steep pitch roof not utilizing an adequate fall protection system. Potential Fall height measured to be 11'-9" with a roof pitch of 12/12.

Issued

Jan 10, 2019

Abate by

Jan 30, 2019

Penalty

Initial $5,174 · Current $0 Reduced

General-duty citation text

29 CFR 1926.502(a)(2): Employers shall provide and install all fall protection systems required by this subpart for an employee, and shall comply with all other pertinent requirements of this subpart before that employee begins the work that necessitates the fall protection.     On January 7, 2019, located on the south side of a residential roof, the employer failed to provided and install a fall protection system prior to an employee installing a vent pipe flashing onto a steep pitch roof. Potential fall height was measured to be 11'-9" with a roof pitch of 12/12.    In accordance with 29 CFR 1903.19(d), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in addition, documentation demonstrating that abatement is complete must be included with your certification.  This documentation may include, but is not limited to, evidence of the purchase or repair of the equipment, photographic or video evidence, or written records.

Issued

Jan 10, 2019

Abate by

Feb 28, 2019

Penalty

Initial $5,174 · Current $0 Reduced

General-duty citation text

29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.    On January 7, 2019 located on the south side of a residential roof, an employee was exposed to a fall hazard while installing a vent pipe flashing onto a steep pitch roof not utilizing an adequate fall protection system and had not been trained by the employer to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards.  Potential Fall height measured to be 11'-9" with a roof pitch of 12/12.      In accordance with 29 CFR 1903.19(d), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in addition, documentation demonstrating that abatement is complete must be included with your certification.  This documentation may include, but is not limited to, evidence of the purchase or repair of the equipment, photographic or video evidence, or written records.