SUNBURY, OH ·
OSHA Inspection: LI ZHONGLONG
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of LI ZHONGLONG in LOT 1328 6866 RINGBILL LOOP, SUNBURY, OH 43074 (NAICS 238170). OSHA activity number 343818605.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- LI ZHONGLONG
- Site address
- LOT 1328 6866 RINGBILL LOOP
- City
- SUNBURY
- State
- OH
- ZIP
- 43074
- Mailing
- 2667 HOMEBRIDGE DRIVE, HILLIARD, OH 43026
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238170
- Employees
- 3
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.20 B01
- Issued
- Apr 8, 2019
- Abate by
- Apr 26, 2019
- Penalty
- Initial $3,978 · Current $3,978
General-duty citation text
29 CFR 1926.20(b)(1): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part. a. On or before February 26, 2019, the employer failed to initiate and maintain a safety and health program such as, but not limited to a personal protective equipment program, thereby exposing employees to struck-by hazards. b. On or before February 26, 2019, the employer failed to initiate and maintain a safety and health program such as, but not limited to a fall protection program, thereby exposing employees to fall hazards of 10 feet, 10 inches. c. On or before February 26, 2019, the employer failed to initiate and maintain a safety and health program such as, but not limited to a ladder safety program, thereby exposing employees to fall hazards of 10 feet, 10 inches.
Recent events (1)
- · Z (S) $3978
1926.21 B02
- Issued
- Apr 8, 2019
- Abate by
- Apr 26, 2019
- Penalty
- Initial $3,978 · Current $3,978
General-duty citation text
29 CFR 1926.21(b)(2): The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury. a. On or before February 26, 2019, the employer failed to train employees on the workplace hazards or the regulations required to control or eliminate the hazards, thereby exposing employees to struck-by, fall, or other hazards.
Recent events (1)
- · Z (S) $3978
1926.100 A
- Issued
- Apr 8, 2019
- Abate by
- Apr 18, 2019
- Penalty
- Initial $3,410 · Current $3,410
General-duty citation text
29 CFR 1926.100(a): Employees working in areas where there is a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns, shall be protected by protective helmets. a. On or before February 26, 2019, where an employee was working at ground level while being exposed to overhead hazards, the employees head was not protected from falling objects, thereby being exposed to a struck-by hazard.
Recent events (1)
- · Z (S) $3410
1926.102 A01
- Issued
- Apr 8, 2019
- Abate by
- Apr 18, 2019
- Penalty
- Initial $3,978 · Current $3,978
General-duty citation text
29 CFR 1926.102(a)(1): The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation. a. On or before February 26, 2019, where an employee was using a pneumatic nail gun to secure siding to the exterior of a dormer, the employees eyes were not protected, thereby being exposed to a struck-by hazard. b. On or before February 26, 2019, where an employee was using a pneumatic nail gun to secure siding to the exterior of wall, the employees eyes were not protected, thereby being exposed to a struck-by hazard. c. On or before February 26, 2019, where an employee was using a circular saw to cut siding for the exterior of a house, the employees eyes were not protected, thereby being exposed to a struck-by hazard.
Recent events (1)
- · Z (S) $3978
1926.501 B13
- Issued
- Apr 8, 2019
- Abate by
- Apr 18, 2019
- Penalty
- Initial $3,978 · Current $3,978
General-duty citation text
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems. a. On or before February 26, 2019, where employees were installing siding to a dormer while standing on the roof of a house, the employees were not protected from falls, thereby being exposed to a 10 foot 10 inch fall hazard.
Recent events (1)
- · Z (S) $3978
1926.1053 B01
- Issued
- Apr 8, 2019
- Abate by
- Apr 18, 2019
- Penalty
- Initial $2,842 · Current $2,842
General-duty citation text
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support. a. On or before February 26, 2019, where an employee used an extension ladder to gain access to the roof, the ladder did not extend at least 3 feet above the edge of the roof, thereby exposing the employee to a 10 foot, 10 inch fall hazard.
Recent events (1)
- · Z (S) $2842
More inspections at LI Zhonglong
View LI Zhonglong's full OSHA safety record →
More inspections in this industry (NAICS 238170)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343818605.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.