OSHA Inspection: SMVP MANAGEMENT INC.

Issued

2019-05-09 00:00:00

Penalty

Initial $3031.00 · Current $2046.00 Reduced

General-duty citation text

29 CFR 1926.304(h)(1): Each circular crosscut table saw was not guarded by a hood which completely enclosed that portion of the saw blade above the table and that portion of the saw above the material being cut:Note:  See paragraph (i)(1) of this section.    29 CFR 1926.300(b)(1): Power operated tool(s), designed to accommodate guards, were not equipped with such guards when in use.    Site: 817 57th Street Brooklyn, NY    On or about 3/14/19    a) The Dewalt table saw used by an employee was missing the blade guard. The table was used to cut baseboards.

Issued

2019-05-09 00:00:00

Penalty

Initial $3031.00 · Current $2046.00 Reduced

General-duty citation text

29 CFR 1926.404(b)(1)(i): Employer did not use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section, or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites.    Site: 817 57th Street Brooklyn, NY    On or about 3/14/19    a) Employees used a Dewalt table and a Makita circular saw. The employer did not provide employees with a GFCI or assure grounding conductor program.

Issued

2019-05-09 00:00:00

Penalty

Initial $3789.00 · Current $2803.00 Reduced

General-duty citation text

29 CFR 1926.1052(c)(1): Stairways having four or more risers or rising more than 30 inches (76 cm), whichever is less, were not equipped with at least one handrail and one stairrail system along each unprotected side or edge.    Site: 817 57th Street Brooklyn, NY    On or about 3/14/19    a) Stairway leading from the sidewalk to residence main entrance was not equipped with a handrail or a stairrail.  b) Stairway leading from the 1st floor to the 2nd floor was not equipped with a handrail or a stairrail.