PATERSON, NJ —
OSHA Inspection: BILL SALEH
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of BILL SALEH in 31 HEMLOCK ST, PATERSON, NJ 07503 (NAICS 236116). OSHA activity number 343860714.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- BILL SALEH
- Site address
- 31 HEMLOCK ST
- City
- PATERSON
- State
- NJ
- ZIP
- 07503
- Mailing
- 1360 CLIFTON AVE., CLIFTON, NJ 07012
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236116
- Employees
- 3
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.404 B01 I
- Issued
- May 22, 2019
- Penalty
- Initial $1,705 · Current $1,705
General-duty citation text
29 CFR 1926.404(b)(1)(i): General. The employer shall use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites. These requirements are in addition to any other requirements for equipment grounding conductors. a) 1st Floor - Dirt Ground: Employee was exposed to electric shock while using electric tools including but not limited to an electric Makita Circular Saw that was not protected by a GFCI or an assured equipment grounding conductor program; on or about 2/7/19.
Recent events (1)
- — Z (S) $1705
1926.602 D
- Issued
- May 22, 2019
- Abate by
- Jun 12, 2019
- Penalty
- Initial $2,842 · Current $2,842
General-duty citation text
29 CFR 1926.602(d): The employer did not certify that each operator had been trained and evaluated as required by paragraph 29 CFR 1910.178(l):Note: The requirements applicable to construction work under paragraph (d) of this section are identical to those set forth at paragraph (l) of 29 CFR 1910.178. a) 1st Floor - Left Side: The employer did not ensure that the operator of the all terrain forklift was certified, on or about 2/22/19.
Recent events (1)
- — Z (S) $2842
1926.1053 B01
- Issued
- May 22, 2019
- Penalty
- Initial $2,842 · Current $2,842
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: a) Interior of Building - Ladder Access - Ground Floor to 1st Floor: Employee engaged in inspection activities was exposed to fall hazards of approximately 13 feet while utilizing an extension ladder that did not extend at least three feet over to access the deck, on or about 2/5/19.
Recent events (1)
- — Z (S) $2842
1926.1053 B04
- Issued
- May 22, 2019
- Penalty
- Initial $2,273 · Current $2,273
General-duty citation text
29 CFR 1926.1053(b)(4): Ladder(s) were used for purposes other than the purpose for which they were designed: a) Interior of Building - 5th Floor to Loft: Employee engaged in inspection activities was exposed to fall hazards of approximately 6 feet while utilizing two step ladders in the closed position, on or about 2/5/19. b) Interior of Building - 5th Floor to Loft: Employee engaged in inspection activities was exposed to fall hazards of approximately 6 feet while utilizing two step ladders in the closed position, on or about 2/7/19.
Recent events (1)
- — Z (S) $2273
More inspections in this industry (NAICS 236116)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343860714.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.