Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,124Inspections Most recent open 2026-08-25 Last loaded 2026-08-28

OSHA Inspection: HAAN ROOFING AND CONSTRUCTION, L.L.C.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of HAAN ROOFING AND CONSTRUCTION, L.L.C. in 600 RIVER DRIVE, MOLINE, IL 61265 (NAICS 238160). OSHA activity number 343870861.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Haan Roofing and Construction, L.L.C. for free Get an email when a new federal OSHA severe-injury report for Haan Roofing and Construction, L.L.C. is published. One employer, no account, unsubscribe in one click.
Site address
600 RIVER DRIVE
City
MOLINE
State
IL
ZIP
61265
Mailing
1620 CROW CREEK RD, DAVENPORT, IA 52807
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
20
Ownership type
Private (A)

4 citations on file for this inspection.

1926.501 B10

Serious Gravity 10 1 instance 4 exposed
Issued
Apr 4, 2019
Abate by
Apr 18, 2019
Penalty
Initial $5,304 · Current $3,450 Reduced
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems or a combination of warning line system and safety monitoring system:    On or about 21 March 2019, employees were exposed to fall hazards approximately 35 feet while engaged in roofing activities on a low-sloped roof.  Fall protection was not being utilized.     Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).
Recent events (2)
  • · I (S) $3450
  • · Z (S) $5304

1926.503 A01

Serious Gravity 10 1 instance 4 exposed
Issued
Apr 4, 2019
Abate by
May 1, 2019
Penalty
Initial $5,304 · Current $3,450 Reduced
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards:    On or about 21 March 2019, at the above addressed jobsite, employees were working from an elevation greater than 35 feet. The employer failed to provide fall protection training to three employees. Discussion with Mr. Gerry Haan indicated that Hector Bajaras was trained in 2002, but the other employees were not trained in a program specific to fall hazards that enables employees to recognize and minimize fall hazards that were present.     Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).
Recent events (2)
  • · I (S) $3450
  • · Z (S) $5304

1926.1053 B01

Deleted Serious Gravity 5 1 instance 4 exposed
Issued
Apr 4, 2019
Abate by
Apr 18, 2019
Penalty
Initial $3,031 · Current $0 Reduced
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (0.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support:  On or about December 1, 2018 through 21 March 2019, at the above addressed jobsite, a portable ladder used to access the roof at the rear of the building did not extend at least three (3') feet above the upper landing surface, thereby exposing employees to the falls while mounting and dismounting the ladder.  Abatement certification is required for this item in accordance with 29 CFR 1903.19(c).
Recent events (2)
  • · I (S) $0
  • · Z (S) $3031

1926.252 A

Other-than-serious 1 instance 4 exposed
Issued
Apr 4, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.252(a): Whenever materials are dropped more than 20 feet to any point lying outside the exterior walls of the building, an enclosed chute of wood, or equivalent material, shall be used. For the purpose of this paragraph, an enclosed chute is a slide, closed in on all sides, through which material is moved from a high place to a lower one.  On or about 21 March 2019, at the above addressed jobsite, employees were dumping materials from a rooftop utilizing a wheelbarrow at approximately 35 feet above ground, onto a non-enclosed tarp that slid trash from the rooftop into dumpsters at ground level. The employer failed to ensure that an enclosed chute that is closed in on all sides, was being used to move material from a high place to a lower one. Employees were thereby exposed to fall hazards from this height due to dumping the trash off the roof.   No abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).
Recent events (2)
  • · I (O) $0
  • · Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 343870861.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.