OSHA Inspection: R&R MILLWORK, INC.

Issued

May 2, 2019

Abate by

Jun 19, 2019

Penalty

Initial $3,978 · Current $2,300 Reduced

General-duty citation text

29 CFR 1910.147(c)(4)(ii)(B): The energy control procedures did not clearly and specifically outline the steps for shutting down, isolating, blocking and securing machines or equipment to control hazardous energy.    a) On or about April 11, 2019, and at times prior, workers were exposed to hazardous energy where specific procedures did not include the steps to isolate and lock out air pressure to shop machines including, but not limited to the CNC Panel Saws.    Abatement Note: Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).

Issued

May 2, 2019

Abate by

Jun 19, 2019

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.147(c)(4)(ii)(C): The energy control procedure did not clearly and specifically outline the steps for placement, removal and transfer of lockout devices or tagout devices and the responsibility for them:  a) On or about April 11, 2019, and at times prior, workers were exposed to hazardous energy where equipment-specific lockout procedures did not include the steps to transfer locks among workers such as but not limited to other shifts, prolonged absences, etc.  Abatement Note: Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).

Issued

May 2, 2019

Abate by

Jun 19, 2019

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.147(c)(4)(ii)(D): The energy control procedures did not clearly and specifically outline the requirements for testing a machine or equipment to determine and verify the effectiveness of lockout devices, tagout devices, and other energy control measures:  a) On or about April 11, 2019, and at times prior, workers were exposed to hazardous energy where equipment-specific lockout procedures did not include the steps to ensure hazardous air pressure was bled from the system prior to starting a maintenance task.  Abatement Note: Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).

Issued

May 2, 2019

Abate by

Jun 19, 2019

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.147(c)(7)(i)(A): Authorized employees did not receive training in the recognition of applicable hazardous energy sources, the type and magnitude of the energy available in the workplace, and the methods and means necessary for energy isolation and control:  a) On or about April 11, 2019, and at times prior, workers were exposed to hazards in that the lockout program, procedures, and training material did not indicate the electrical power and air pressure present in the workplace or alternatively, at each separate machine covered by a lockout procedure.  Abatement Note: Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).