DAPHNE, AL ·
OSHA Inspection: AMILCAR DAVID
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of AMILCAR DAVID in 9248 DIAMANTE BLVD. LOT 49 DIAMANTE, DAPHNE, AL 36526 (NAICS 238130). OSHA activity number 343949020.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- AMILCAR DAVID
- Site address
- 9248 DIAMANTE BLVD. LOT 49 DIAMANTE
- City
- DAPHNE
- State
- AL
- ZIP
- 36526
- Mailing
- 4251 STATE HIGHWAY 104 LOT 22, SILVERHILL, AL 36576
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 5
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.102 A01
- Issued
- May 7, 2019
- Abate by
- May 17, 2019
- Penalty
- Initial $3,410 · Current $3,410
General-duty citation text
29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical agents: a) At 9248 Diamante Blvd., Lot 49 Diamante, Daphne, Alabama: On or about April 22, 2019 and at times prior; the employer allowed his employees to operate pneumatic nail guns without eye protection exposing his employees to struck-by hazards.
Recent events (1)
- · Z (S) $3410
1926.501 B13
- Issued
- May 7, 2019
- Abate by
- May 17, 2019
- Penalty
- Initial $3,410 · Current $3,410
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): a) At 9248 Diamante Blvd., Lot 49 Diamante, Daphne, Alabama: On or about April 22, 2019 and at times prior; the employer allowed his employees to perform framing activities without fall protection exposing his employees to a fall hazard of 10.5 feet to the concrete floor below.
Recent events (1)
- · Z (S) $3410
1926.503 A01
- Issued
- May 7, 2019
- Abate by
- May 17, 2019
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: a) At 9248 Diamante Blvd., Lot 49 Diamante, Daphne, Alabama: On or about April 22, 2019 and at times prior; the employer allowed his employees to perform framing activities without first ensuring his employees were trained on the hazards associated with falls to include but not limited to setting up and inspecting fall protection exposing his employees to a fall hazard of 10.5 feet to the concrete floor below.
Recent events (1)
- · Z (S) $0
1926.1053 B01
- Issued
- May 7, 2019
- Abate by
- May 17, 2019
- Penalty
- Initial $3,410 · Current $3,410
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: a) At 9248 Diamante Blvd., Lot 49 Diamante, Daphne, Alabama: On or about April 22, 2019 and at times prior; the employer allowed his employees to use a 8 foot a-frame ladder to gain access to the top of the ceiling joists and the rails of the ladder did not extend three feet above the landing to provide safe access exposing his employees to a fall hazard of up to 10.3 feet to the concrete floor below.
Recent events (1)
- · Z (S) $3410
1926.1053 B13
- Issued
- May 7, 2019
- Abate by
- May 17, 2019
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(13): The top or top step of a stepladder was used as a step: a) At 9248 Diamante Blvd., Lot 49 Diamante, Daphne, Alabama: On or about April 22, 2019 and at times prior; the employer allowed his employees to use a 8 foot a-frame ladder to gain access to the top of the ceiling joists and the employees used the top step each time exposing his employees to a fall hazard of up to 10.3 feet to the concrete floor below.
Recent events (1)
- · Z (S) $0
More inspections in this industry (NAICS 238130)
More inspections in AL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343949020.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.