BUFFALO, NY ·
OSHA Inspection: KANAKA CONSTRUCTION MANAGEMENT, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of KANAKA CONSTRUCTION MANAGEMENT, INC. in 1685-95 ELMWOOD AVENUE, BUFFALO, NY 14207 (NAICS 236220). OSHA activity number 343982344.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- KANAKA CONSTRUCTION MANAGEMENT, INC.
- Site address
- 1685-95 ELMWOOD AVENUE
- City
- BUFFALO
- State
- NY
- ZIP
- 14207
- Mailing
- 2150 WEHRLE DRIVE, WILLIAMSVILLE, NY 14221
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236220
- Employees
- 2
- Ownership type
- Private (A)
Citations
2 citations on file for this inspection.
1926.1052 C01
- Issued
- Jun 27, 2019
- Penalty
- Initial $1,232 · Current $760 Reduced
General-duty citation text
29 CFR 1926.1052(c)(1): Stairways having four or more risers or rising more than 30 inches (76 cm), whichever is less, were not equipped with at least one handrail and one stairrail system along each unprotected side or edge: a) On or about 4/29/19, at the east entrance area of the site, Buffalo, NY. The stairways, with 10 riser steps, lacked at least one handrail. NO ABATEMENT CERTIFICATION REQUIRE
Recent events (2)
- · I (S) $760
- · Z (S) $1232
1926.404 B01 II
- Issued
- Jun 27, 2019
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.404(b)(1)(ii): On a construction site, where an assured equipment grounding program was not utilized, all 120-volt, single-phase, 15 and 20 ampere receptacle outlets which were not a part of the permanent wiring of the building or structure and which are in use by employees did not have approved ground fault circuit interrupters for personal protection: a) On or about 4/29/19, at the first floor area of the site, Buffalo, NY. A circular saw and a sander, that drew power through a flexible cord that was plugged into wall receptacles, did not have approved ground fault circuit interrupters for personal protection. NO ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
- · I (O) $0
- · Z (O) $0
More inspections at Kanaka Construction Management, INC.
View Kanaka Construction Management, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 236220)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 343982344.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.