Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: MITCHELL DECKER

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of MITCHELL DECKER in 6302 70TH ST., LUBBOCK, TX 79424 (NAICS 238160). OSHA activity number 343989448.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Mitchell Decker — free Get an email when a new federal OSHA severe-injury report for Mitchell Decker is published. One employer, no account, unsubscribe in one click.
Establishment
MITCHELL DECKER
Site address
6302 70TH ST.
City
LUBBOCK
State
TX
ZIP
79424
Mailing
2109 46TH ST., LUBBOCK, TX 79412
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
6
Ownership type
A

6 citations on file for this inspection.

1926.100 A

Serious Gravity 1 1 instance 2 exposed
Issued
Jul 8, 2019
Abate by
Aug 1, 2019
Penalty
Initial $1,705 · Current $1,705
29 CFR 1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets:  a) At the construction site, employees working without hard hats were exposed to struck-by hazards while working on the ground level as other employees performed roofing work above.
Recent events (1)
  • — Z (S) $1705

1926.102 A01

Serious Gravity 1 1 instance 2 exposed
Issued
Jul 8, 2019
Abate by
Aug 1, 2019
Penalty
Initial $1,705 · Current $1,705
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation:  a) At the construction site, employees performing roofing work were exposed to struck-by hazards while operating pneumatic nail guns without eye protection.
Recent events (1)
  • — Z (S) $1705

1926.501 B11

Serious Gravity 10 1 instance 2 exposed
Issued
Jul 8, 2019
Abate by
Aug 1, 2019
Penalty
Initial $3,978 · Current $3,978
29 CFR 1926.501(b)(11): "Steep roofs." Each employee on a steep roof with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems with toeboards, safety net systems, or personal fall arrest systems.  a) At the construction site, employees engaged in roofing activities without fall protection were exposed to fall hazards in excess of six feet.
Recent events (1)
  • — Z (S) $3978

1926.503 A01

Serious Gravity 1 1 instance 2 exposed
Issued
Jul 8, 2019
Abate by
Aug 1, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a) At the construction site, employees performing roofing work without fall protection were not trained to enable them to recognize fall hazards and the procedures to follow in order to minimize those hazards.
Recent events (1)
  • — Z (S) $0

1926.1053 B01

Serious Gravity 1 1 instance 2 exposed
Issued
Jul 8, 2019
Abate by
Aug 1, 2019
Penalty
Initial $1,705 · Current $1,705
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:  Employees engaged in framing activities were exposed to fall hazards while using a ladder that did not extend at least three feet above the roof's landing.
Recent events (1)
  • — Z (S) $1705

1926.1060 A

Serious Gravity 1 1 instance 10 exposed
Issued
Jul 8, 2019
Abate by
Aug 1, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards:  a) At the construction site, employees performing roofing work had not been trained to recognize hazards related to ladders and the procedures to follow that would minimize the hazards.
Recent events (1)
  • — Z (S) $0

View Mitchell Decker's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343989448.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.