Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: VL ROOFING & SHEET METAL INC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of VL ROOFING & SHEET METAL INC in 1830 E PERSHING ST, APPLETON, WI 54911 (NAICS 238160). OSHA activity number 344145396.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch VL Roofing & Sheet Metal INC — free Get an email when a new federal OSHA severe-injury report for VL Roofing & Sheet Metal INC is published. One employer, no account, unsubscribe in one click.
Site address
1830 E PERSHING ST
City
APPLETON
State
WI
ZIP
54911
Mailing
1465 DONALD ST, GREEN BAY, WI 54304
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
3
Ownership type
A

6 citations on file for this inspection.

1926.20 B02

Serious Gravity 5 1 instance 3 exposed
Issued
Aug 7, 2019
Penalty
Initial $3,410 · Current $3,410
29 CFR 1926.20(b)(2): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part; such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers.  On July 11, 2019 at 1830 E Pershing Street in Appleton, the employer did not ensure that a competent person was performing frequent and regular inspections that could have recognized the potential for fall from elevation hazards associated with damaged personal fall arrest equipment available for use on site and with employees using an extension ladder to access/egress a roof surface without the side rails extended at three free above the upper landing.
Recent events (1)
  • — Z (S) $3410

1926.502 D21

Serious Gravity 5 1 instance 2 exposed
Issued
Aug 7, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.502(d)(21): Personal fall arrest systems shall be inspected prior to each use for wear, damage and other deterioration, and defective components shall be removed from service.  On July 11, 2019 at 1830 E Pershing Street in Appleton, damaged personal fall arrest system equipment was on the worksite available for employee use; two Guardian lifelines were frayed, kinked, and had fiber separation.
Recent events (1)
  • — Z (S) $0

1926.1053 B01

Serious Gravity 5 1 instance 3 exposed
Issued
Aug 7, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grab-rail, shall be provided to assist employees in mounting and dismounting the ladder.  On July 11, 2019 at 1830 E Pershing Street in Appleton, employees were using an extension ladder to access/egress a roof edge seventeen and one half feet above surface level without the side rails extended at least three feet above the upper landing.
Recent events (1)
  • — Z (S) $0

1926.501 B13

Serious Gravity 5 1 instance 3 exposed
Issued
Aug 7, 2019
Penalty
Initial $2,842 · Current $2,842
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure.  On July 11, 2019 at 1830 E Pershing Street in Appleton, employees were working on a roof at seventeen and one half feet above surface level without utilizing fall protection equipment.
Recent events (1)
  • — Z (S) $2842

1926.503 A02 III

Other-than-serious 1 instance 3 exposed
Issued
Aug 7, 2019
Abate by
Sep 12, 2019
Penalty
Initial $319 · Current $319
29 CFR 1926.503(a)(2)(iii): The employer shall assure that each employee has been trained, as necessary, by a competent person qualified in the use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used.  On July 11, 2019 at 1830 E Pershing Street in Appleton, the employer did not provide required fall protection safety training for employees who did not associate fall from elevation hazards when walking/working on a low slope roof surface with unprotected edges without utilizing fall protection equipment.
Recent events (1)
  • — Z (O) $319

1926.503 B01

Other-than-serious 1 instance 3 exposed
Issued
Aug 7, 2019
Abate by
Sep 12, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.503(b)(1): The employer shall verify compliance with paragraph (a) of this section by preparing a written certification record. The written certification record shall contain the name or other identity of the employee trained, the date(s) of the training, and the signature of the person who conducted the training or the signature of the employer. If the employer relies on training conducted by another employer or completed prior to the effective date of this section, the certification record shall indicate the date the employer determined the prior training was adequate rather than the date of actual training.  On July 11, 2019 at 1830 E Pershing Street in Appleton, the employ, the employer did not provide written employee fall protection safety training certification for employees walking/working from roof surfaces at heights greater than six feet.
Recent events (1)
  • — Z (O) $0

View VL Roofing & Sheet Metal INC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344145396.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.