Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: AKI CORPORATION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of AKI CORPORATION in 9451 AINSLIE ST., SCHILLER PARK, IL 60176 (NAICS 238910). OSHA activity number 344302906.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch AKI Corporation — free Get an email when a new federal OSHA severe-injury report for AKI Corporation is published. One employer, no account, unsubscribe in one click.
Establishment
AKI CORPORATION
Site address
9451 AINSLIE ST.
City
SCHILLER PARK
State
IL
ZIP
60176
Mailing
8580 W. FOSTER AVE UNIT 710, NORRIDGE, IL 60706
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238910
Employees
17
Ownership type
A

4 citations on file for this inspection.

1926.453 B02 V

Serious Gravity 5 1 instance 5 exposed
Issued
Sep 30, 2019
Abate by
Oct 4, 2019
Penalty
Initial $3,789 · Current $1,500 Reduced
29 CFR 1926.453(b)(2)(v):  A body belt was not worn and/or a lanyard was not attached to the boom or the basket when working from an aerial lift:      Note: As of January 1, 1998, subpart M of this part (1926.502(d)) provides that body belts are not acceptable as part of a personal fall arrest system:       a)  On September 12, 2019, employees were exposed to the hazard of falling up to approximately 22 feet while working from the SkyJack aerial lift platform without wearing a full body harness with a lanyard attached to the boom or basket.     In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).
Recent events (2)
  • — I (S) $1500
  • — Z (S) $3789

1926.501 B01

Serious Gravity 10 1 instance 3 exposed
Issued
Sep 30, 2019
Abate by
Oct 4, 2019
Penalty
Initial $5,304 · Current $3,047 Reduced
29 CFR 1926.501(b)(1): Each employee on a walking/working surface with an unprotected side or edge which was 6 feet (1.8 m) or more above a lower level was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems:    a)  On September 12, 2019, employees engaged in roof demolition work were not protected from fall hazards while working at an elevation of approximately 22 feet above the ground.     In accordance with 29 CFR 1903.19(d), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in addition, documentation demonstrating that abatement is complete must be included with your certification.  This documentation may include, but is not limited to, evidence of the purchase or repair of the equipment, photographic or video evidence of abatement, or other written records.
Recent events (2)
  • — I (S) $3046.5
  • — Z (S) $5304

1926.404 B01 II

Other-than-serious 1 instance 2 exposed
Issued
Sep 30, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.404(b)(1)(ii):  Where an assured equipment grounding program was not utilized, receptacles were not protected with ground fault circuit interrupters when on a two-wire, single- phase portable or vehicle-mounted generator rated more than 5kW, or where the circuit conductors of the generator were not insulated from the generator frame and all other grounded surfaces:    a)  On September 12, 2019, employees were provided and used 120/240 Volt, Honda Power Stroke Portable Generator with receptacle not protected with ground fault circuit interrupters to power equipment and tools onsite.  No abatement certification or documentation is required for this item.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

1926.503 B01

Other-than-serious 1 instance 5 exposed
Issued
Sep 30, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.503(b)(1):  The employer did not verify compliance with paragraph (a) of this section by preparing a written (training) certification record including the name or other identity of the employee trained, the date(s) of the training, and the signature of the person who conducted the training or the signature of the employer:     a)  On or about September 12, 2019, the employer did not maintain records or certification of fall protection training for employees exposed to fall hazards.  No abatement certification or documentation is required for this item.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344302906.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.