SAN ANTONIO, TX —
OSHA Inspection: EUSEBIO ORTIZ
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of EUSEBIO ORTIZ in 7406 CHAMPION CREEK, SAN ANTONIO, TX 78252 (NAICS 238130). OSHA activity number 344405295.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- EUSEBIO ORTIZ
- Site address
- 7406 CHAMPION CREEK
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78252
- Mailing
- 7814 GLEN LAKE, SAN ANTONIO, TX 78239
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 2
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.100 A
- Issued
- Nov 4, 2019
- Abate by
- Nov 12, 2019
- Penalty
- Initial $1,705 · Current $1,705
General-duty citation text
29 CFR 1926.100(a): Employees were not protected by protective helmets while working in areas where there was a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns: On or about October 25, 2019, and at times prior thereto, employees were exposed to the hazard of being struck-by falling objects, while working on the ground level below without hardhats to protect them from overhead hazards.
Recent events (1)
- — Z (S) $1705
1926.102 A01
- Issued
- Nov 4, 2019
- Abate by
- Nov 12, 2019
- Penalty
- Initial $2,842 · Current $2,842
General-duty citation text
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles: a) On or about October 25, 2019, and at times prior thereto, employees were exposed to a struck-by flying projectile hazard while using a Skil Circular Saw to cut boards and panels without safety glasses. b) On or about October 25, 2019, and at times prior thereto, employees were exposed to a struck-by flying projectile hazard while using a Bosch Circular Saw to cut boards and panels without safety glasses. c) On or about October 25, 2019, and at times prior thereto, employees were exposed to a struck-by flying projectile hazard while using a JITOOL Nailer and a Hyper Tough Claw Hammer to install cornice without safety glasses.
Recent events (1)
- — Z (S) $2842
1926.501 B13
- Issued
- Nov 4, 2019
- Abate by
- Nov 12, 2019
- Penalty
- Initial $2,273 · Current $2,273
General-duty citation text
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501(b): On or about October 25, 2019, and at times prior thereto, employees without fall protection were exposed to a fall hazard greater than 6 feet to the unpaved ground below while installing cornice.
Recent events (1)
- — Z (S) $2273
1926.503 A01
- Issued
- Nov 4, 2019
- Abate by
- Nov 12, 2019
- Penalty
- Initial $2,273 · Current $2,273
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: In Front of the residential roof: On or about October 25, 2019, and at times prior thereto, employees without fall protection were exposed to a fall hazard greater than 6 feet to the unpaved ground below while installing cornice.
Recent events (1)
- — Z (S) $2273
More inspections at Eusebio Ortiz
View Eusebio Ortiz's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344405295.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.