ORMOND BEACH, FL —
OSHA Inspection: HIGH RISE QUEEN INC.
Federal Agency inspection · Safety discipline
At a glance
On , OSHA opened a federal Agency safety inspection of HIGH RISE QUEEN INC. in 1575 OCEAN SHORE BLVD, ORMOND BEACH, FL 32174 (NAICS 561790). OSHA activity number 344433859.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- HIGH RISE QUEEN INC.
- Site address
- 1575 OCEAN SHORE BLVD
- City
- ORMOND BEACH
- State
- FL
- ZIP
- 32174
- Mailing
- 120 TARRACINA WAY, DAYTONA BEACH, FL 32117
What kind of inspection was it?
- Inspection type
- Federal Agency (M)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Last modified
- Data loaded
Establishment context
- NAICS code
- 561790
- Employees
- 4
- Ownership type
- A
Citations
4 citations on file for this inspection.
1910.27 B01 II
- Issued
- Feb 20, 2020
- Penalty
- Initial $4,048 · Current $4,048
General-duty citation text
29 CFR 1910.27(b)(1)(ii): The employer did not ensure that no employee uses any anchorage before the employer has obtained written information from the building owner that each anchorage meets the requirements of paragraph (b)(1)(i) of this section and that the employer must keep the information for the duration of the job. a. On or about November 7, 2019, the employer did not obtain or maintain any information from the building owner establishing that the anchor points on the roof, including but not limited to, the angle iron stanchion of an air-conditioning mounting bracket, met the 5,000-pound requirement of this standard, exposing employees to fall hazards.
Recent events (2)
- — C (S) $4048
- — Z (S) $4048
1910.27 B02 V
- Issued
- Feb 20, 2020
- Abate by
- Apr 7, 2020
- Penalty
- Initial $13,494 · Current $13,494
General-duty citation text
29 CFR 1910.27(b)(2)(v): 29 CFR 1910.27(b)(2)(v): The employer did not ensure that the rope descent system had proper rigging, including anchorages and tiebacks, with particular emphasis on providing tiebacks when counterweights, cornice hooks, or similar non-permanent anchorages were used: a. On or about November 7, 2019, the working line rope and the safety life line rope of the rope descent system were not secured to the Versabeam spine handle nor to the anchor point on the roof, in that the butterfly loop of the poachers knot was not connected back through the D ring carabiner, exposing employees to a 120-foot fall hazard
Recent events (2)
- — C (S) $13494
- — Z (S) $13494
1910.27 B02 VI
- Issued
- Feb 20, 2020
- Penalty
- Initial $4,048 · Current $4,048
General-duty citation text
29 CFR 1910.27(b)(2)(vi): The employer did not ensure that each employee using a rope descent system, used a separate, independent personal fall arrest system that met the requirements of subpart I of this part: a. On or about November 7, 2019, both the working line rope and the safety "life" line rope of the rope descent system were attached to the same angle iron stanchion of an air-conditioning mounting bracket on the roof, exposing employees to 120-foot fall hazard.
Recent events (2)
- — C (S) $4048
- — Z (S) $4048
1910.30 A03 IV
- Issued
- Feb 20, 2020
- Abate by
- Apr 7, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.30(a)(3)(iv): The employer did not train each employee on the correct use of personal fall protection systems and equipment, including, but not limited to, proper hook-up, anchoring, and tie-off techniques, and methods of equipment inspection and storage, as specified by the manufacturer: a. On or about November 7, 2019, the employer did not train the employees in the correct use of personal fall protection systems and equipment, including, but not limited to, proper hook-up, anchoring, and tie-off techniques, and methods of equipment inspection and storage, as specified by the manufacturer, exposing them to fall hazards.
Recent events (2)
- — C (O) $0
- — Z (O) $0
More inspections in this industry (NAICS 561790)
More inspections in FL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344433859.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.