Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,549Inspections Most recent open 2026-08-27 Last loaded 2026-08-31

OSHA Inspection: 186 ROOFING LLC

Programmed Related inspection · Safety discipline

On , OSHA opened a programmed Related safety inspection of 186 ROOFING LLC in 10085 NEW CALIFORNIA DRIVE, PLAIN CITY, OH 43064 (NAICS 238160). OSHA activity number 344502216.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch 186 Roofing LLC for free Get an email when a new federal OSHA severe-injury report for 186 Roofing LLC is published. One employer, no account, unsubscribe in one click.
Establishment
186 ROOFING LLC
Site address
10085 NEW CALIFORNIA DRIVE
City
PLAIN CITY
State
OH
ZIP
43064
Mailing
8886 COUNTY ROAD 186, DUNDEE, OH 44624
Inspection type
Programmed Related (I)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
4
Ownership type
Private (A)

4 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 1 instance 4 exposed
Issued
Jan 6, 2020
Penalty
Initial $3,978 · Current $3,978
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502.  a.  Locate at 10085 New California Drive, Plain City, Ohio:  On or about December 11, 2019, the employer failed to ensure that employees working from the roof top removing shingles, were protected  from falls.  The employees were exposed to a fall hazard of approximately 19 feet without any means of fall protection.
Recent events (2)
  • · I (S) $3978
  • · Z (S) $3978

1926.20 B01

Serious Gravity 10 1 instance 4 exposed
Issued
Jan 6, 2020
Abate by
Jan 16, 2020
Penalty
Initial $3,978 · Current $0 Reduced
29 CFR 1926.20(b)(1): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part.  a. Located at 10085 New California Drive, Plain City, Ohio: On or about December 11, 2019, the employer did not maintain a safety and health program to ensure hazard detection, and correction while performing shingling work onsite.  Four employees were unprotected from the rooftop of a residential home.  The fall distance was approximately 19 feet to the ground.
Recent events (2)
  • · I (S) $0
  • · Z (S) $3978

1926.21 B02

Serious Gravity 10 1 instance 4 exposed
Issued
Jan 6, 2020
Abate by
Jan 16, 2020
Penalty
Initial $3,978 · Current $0 Reduced
29 CFR 1926.21(b)(2): The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury.  a.  Locate at 10085 New California Drive, Plain City, Ohio:  On or about December 11, 2019, the employer failed to instruct employees on the avoidance of unsafe conditions while they performed asphalt roof shingle removal.
Recent events (2)
  • · I (S) $0
  • · Z (S) $3978

1926.1053 B01

Serious Gravity 10 1 instance 4 exposed
Issued
Jan 6, 2020
Abate by
Jan 16, 2020
Penalty
Initial $3,978 · Current $0 Reduced
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.  a. Located at 10085 New California Drive, Plain City, Ohio: On or about December 11, 2019, the employer did not extend the ladder at least three feet above the upper landing surface, to which employees had used to gain access to the roof top.  Four employees were exposed  to fall distance of approximately 19 feet from the eave of the roof top to the ground level.
Recent events (2)
  • · I (S) $0
  • · Z (S) $3978

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 344502216.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.