SAN ANTONIO, TX ·
OSHA Inspection: REFUGIO VILLEGAS
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of REFUGIO VILLEGAS in 6038 OLD PEARSAL ROAD, SAN ANTONIO, TX 78242 (NAICS 238130). OSHA activity number 344561485.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- REFUGIO VILLEGAS
- Site address
- 6038 OLD PEARSAL ROAD
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78242
- Mailing
- 422 MERCEDES, SAN ANTONIO, TX 78207
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 3
- Ownership type
- Private (A)
Citations
5 citations on file for this inspection.
1926.102 A01
- Issued
- Mar 20, 2020
- Abate by
- Apr 9, 2020
- Penalty
- Initial $2,313 · Current $2,313
General-duty citation text
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation: Western facing side of commercial building 6038 Old Pearsall Road: On or about January 14, 2020, and at times prior thereto, employees were exposed to struck by hazards while installing fascia board with a pneumatic nail gun without wearing eye protection.
Recent events (3)
- · A (S) $2313
- · I (S) $1100
- · Z (S) $2313
1926.405 G01 III D
- Issued
- Mar 20, 2020
- Abate by
- Apr 9, 2020
- Penalty
- Initial $2,892 · Current $2,892
General-duty citation text
29 CFR 1926.405(g)(1)(iii)(D): Flexible cords were attached to building surfaces: a). Western facing side of commercial building 6038 Old Pearsall Road: On or about January 14, 2020 and at times prior thereto, employees were exposed to electrical hazards while using an extension cord that was attached to the rooftop area and was used as a power source for a Dewalt portable air compressor. b). Western facing side of commercial building 6038 Old Pearsall Road: On or about January 14, 2020 and at times prior thereto, employees were exposed to electrical hazards while using an extension cord that was attached to the rooftop area and was used as a power source for a hand held circular skill saw.
Recent events (3)
- · A (S) $2892
- · I (S) $1200
- · Z (S) $2892
1926.451 C02 IV
- Issued
- Mar 20, 2020
- Penalty
- Initial $4,048 · Current $4,048
General-duty citation text
29 CFR 1926.451(c)(2)(iv): Front-end loaders and similar pieces of equipment were used to support scaffold platforms without being specifically designed by the manufacturer for such use: Western facing side of commercial building 6038 Old Pearsall Road: On or about January 14, 2020, and at times prior thereto, employees were exposed to fall hazards while using a Genie Telehandler that was supporting a plywood pallet to elevate personnel who were applying exterior fascia board without the use of fall protection.
Recent events (3)
- · A (S) $4048
- · I (S) $1550
- · Z (S) $4048
1926.451 G01
- Issued
- Mar 20, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section: Western facing side of commercial building 6038 Old Pearsall Road: On or about January 14, 2020, and at times prior thereto, employees were exposed to fall hazards while using a Genie Telehandler that was supporting a plywood pallet to elevate personnel who were applying exterior fascia board without the use of fall protection.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1926.602 D
- Issued
- Mar 20, 2020
- Penalty
- Initial $4,048 · Current $4,048
General-duty citation text
29 CFR 1926.602(d): The employer did not certify that each operator had been trained and evaluated as required by paragraph 29 CFR 1910.178(l): Note: The requirements applicable to construction work under paragraph (d) of this section are identical to those set forth at paragraph (l) of 29 CFR 1910.178. 29 CFR 1910.178(l)(1)(i): The employer did not ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l): AS REFERENCED BY THE NOTE CONTAINED IN 1926.602(d): Western facing side of commercial building 6038 Old Pearsall Road: On or about January 14, 2020, and at times prior thereto, employees were exposed to a fall hazards, while operating a Genie Telehandler prior to receiving training and being certified as a competent operator.
Recent events (3)
- · A (S) $4048
- · I (S) $1550
- · Z (S) $4048
More inspections in this industry (NAICS 238130)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 344561485.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.