LUBBOCK, TX ·
OSHA Inspection: A.J. ADKINS
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of A.J. ADKINS in 12118 SALISBURY BLVD., LUBBOCK, TX 79424 (NAICS 238130). OSHA activity number 344591359.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- A.J. ADKINS
- Site address
- 12118 SALISBURY BLVD.
- City
- LUBBOCK
- State
- TX
- ZIP
- 79424
- Mailing
- 4914 47TH ST., LUBBOCK, TX 79414
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 5
- Ownership type
- Private (A)
Citations
5 citations on file for this inspection.
1926.102 A01
- Issued
- Apr 21, 2020
- Abate by
- May 15, 2020
- Penalty
- Initial $1,735 · Current $1,735
General-duty citation text
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation: a) At the construction site, employees performing framing work were exposed to struck-by hazards while operating pneumatic nail guns without eye protection.
Recent events (1)
- · Z (S) $1735
1926.501 B13
- Issued
- Apr 21, 2020
- Abate by
- May 15, 2020
- Penalty
- Initial $1,735 · Current $1,735
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501(b): a) At the construction site, employees engaged in framing activities without fall protection were exposed to fall hazards in excess of six feet.
Recent events (1)
- · Z (S) $1735
1926.503 A01
- Issued
- Apr 21, 2020
- Abate by
- May 15, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: a) At the construction site, employees performing framing activities without fall protection were not trained to enable them to recognize fall hazards and the procedures to follow in order to minimize those hazards.
Recent events (1)
- · Z (S) $0
1926.1053 B01
- Issued
- Apr 21, 2020
- Abate by
- May 15, 2020
- Penalty
- Initial $1,735 · Current $1,735
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: a) At the construction site, employees engaged in framing activities were exposed to fall hazards while using a ladder that did not extend at least three feet above the roof's landing.
Recent events (1)
- · Z (S) $1735
1926.1060 A
- Issued
- Apr 21, 2020
- Abate by
- May 15, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards: a) At the construction site, employees performing framing activities had not been trained to recognize hazards related to ladders and the procedures to follow that would minimize the hazards.
Recent events (1)
- · Z (S) $0
More inspections in this industry (NAICS 238130)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 344591359.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.