Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,198,892Inspections Most recent open 2026-09-03 Last loaded 2026-09-07

OSHA Inspection: MARIO GONZALEZ JR.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of MARIO GONZALEZ JR. in 1362 WILSON ROAD, CONROE, TX 77304 (NAICS 238130). OSHA activity number 344661251.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Mario Gonzalez JR. for free Get an email when a new federal OSHA severe-injury report for Mario Gonzalez JR. is published. One employer, no account, unsubscribe in one click.
Establishment
MARIO GONZALEZ JR.
Site address
1362 WILSON ROAD
City
CONROE
State
TX
ZIP
77304
Mailing
757 SHELLEE DRIVE, CONROE, TX 77303
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
7
Ownership type
Private (A)

8 citations on file for this inspection.

1926.102 A01

Serious Gravity 5 1 instance 7 exposed
Issued
May 28, 2020
Abate by
Jun 16, 2020
Penalty
Initial $2,892 · Current $2,892
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation.  On or about February 25, 2020, and at times prior thereto, employees on the roof of a newly constructed commercial building located on Wilson Rd, in Conroe, TX, were exposed to a struck-by hazard while operating pneumatic nail guns and handsaws without wearing eye protection.
Recent events (2)
  • · I (S) $2892
  • · Z (S) $2892

1926.451 B02

Serious Gravity 5 2 instances 4 exposed
Issued
May 28, 2020
Abate by
Jun 16, 2020
Penalty
Initial $2,892 · Current $2,892
29 CFR 1926.451(b)(2): Scaffold platforms and walkways were not at least 18 inches wide:   On or about February 25, 2020, and at times prior thereto, at a newly constructed commercial building on Wilson Rd, in Conroe, TX, employees located:   a.  On the East side of the building, were exposed to a fall hazard while working on a scaffold platform / walkway that was not 18 inches wide.  b. On the South side of the building, were exposed to a fall hazard while working on a scaffold platform / walkway that was not 18 inches wide.
Recent events (2)
  • · I (S) $2892
  • · Z (S) $2892

1926.451 B10

Serious Gravity 5 1 instance 2 exposed
Issued
May 28, 2020
Abate by
Jun 16, 2020
Penalty
Initial $0 · Current $0
29 CFR 1926.451(b)(10): Scaffold components manufactured by different manufacturers were modified in order to intermix them and a competent person did not determine that the resulting scaffold was structurally sound:  On or about February 25, 2020, and at times prior thereto, at the construction site,  employees were exposed to fall hazards when conducting roofing and framing activities from scaffolds with components intermixed from different manufacturers.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.451 C02

Serious Gravity 5 1 instance 2 exposed
Issued
May 28, 2020
Abate by
Jun 16, 2020
Penalty
Initial $0 · Current $0
29 CFR 1926.451(c)(2): Supported scaffold poles, legs, posts, frames, and uprights did not bear on base plates and mud sills or other adequate firm foundation:  On or about February 25, 2020, and at times prior thereto, on the East side of a newly constructed commercial building, employees were exposed to a fall hazard while working from a fabricated frame scaffold, which did not have base plates installed.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.451 E01

Serious Gravity 5 1 instance 2 exposed
Issued
May 28, 2020
Abate by
Jun 16, 2020
Penalty
Initial $0 · Current $0
29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, structure, personnel hoist, or similar surface was not used.  Crossbraces were used as a means of access.  On or about February 25, 2020, and at times prior thereto, on the East side of a newly built commercial building,  employees were exposed to a fall hazard when performing framing activities from a fabricated frame scaffolding without a ladder or other safe means of access.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.451 F16

Serious Gravity 5 1 instance 2 exposed
Issued
May 28, 2020
Abate by
Jun 16, 2020
Penalty
Initial $0 · Current $0
29 CFR 1926.451(f)(16): Scaffold platforms or planks deflected more than 1/60 of their span when loaded:  On or about February 25, 2020, and at times prior thereto, on the East side of a newly built commercial building, employees were exposed to a fall hazard exceeding 10 feet while working from a fabricated frame scaffold performing masonry work with a deflected scaffold platform.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.501 B11

Serious Gravity 10 1 instance 3 exposed
Issued
May 28, 2020
Abate by
Jun 16, 2020
Penalty
Initial $4,048 · Current $4,048
29 CFR 1926.501(b)(11): Each employee on a steep roof with unprotected sides and edges 6 feet (1.8 m) or more above lower levels was not protected from falling by guardrail systems with toeboards, safety net systems, or personal fall arrest systems:  On or about February 25, 2020, and at times prior thereto, on the steep roof of a newly constructed commercial building, employees were exposed to a fall hazard exceeding six feet when performing roofing work without a fall protection system.
Recent events (2)
  • · I (S) $4048
  • · Z (S) $4048

1926.454 A

Other-than-serious 1 instance 4 exposed
Issued
May 28, 2020
Abate by
Jun 16, 2020
Penalty
Initial $0 · Current $0
29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.  On or about February 25, 2020, and at times prior thereto, on the East side of a newly constructed commercial building, employees were working on a scaffold, installing framing, without having been trained to recognize and minimize hazards associated with the scaffold.
Recent events (2)
  • · I (O) $0
  • · Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 344661251.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.