FORT WORTH, TX ·
OSHA Inspection: ALEXANDER GALO
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of ALEXANDER GALO in 16017 TOTTENHALL PASS, FORT WORTH, TX 76244 (NAICS 238160). OSHA activity number 344678305.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ALEXANDER GALO
- Site address
- 16017 TOTTENHALL PASS
- City
- FORT WORTH
- State
- TX
- ZIP
- 76244
- Mailing
- 2131 HUNTINGTON DR., ARLINGTON, TX 76010
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 3
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.501 B13
- Issued
- Mar 20, 2020
- Penalty
- Initial $2,892 · Current $2,892
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): On or about March 6, 2020, and at times prior thereto, employees engaged in roofing activities were not provided fall protection and exposed to an unprotected fall hazard of approximately 12 feet to the ground below.
Recent events (1)
- · Z (S) $2892
1926.1053 B01
- Issued
- Mar 20, 2020
- Penalty
- Initial $2,892 · Current $2,892
General-duty citation text
29 CFR 1926.1053(b)(1): Where (a) portable ladder(s) was/were used for access to an upper level landing surface and the ladder's length did not allow the ladder side rails to extend at least 3 feet (0.9 m) above the upper landing surface being accessed, the ladder was not secured at its top to a rigid support that will not deflect, and/or a grasping device was not provided to assist employees in mounting and dismounting the ladder. On or about March 6, 2020, and at times prior thereto, the employer did not ensure employees safely used the ladder to gain access to the residential roof. The ladder was not secured at the top and did not extend three feet above the landing surface. Employees were exposed to a fall hazard of approximately 12 feet.
Recent events (1)
- · Z (S) $2892
1926.1053 B04
- Issued
- Mar 20, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(4): Ladders were used for purposes other than the purposes for which they were designed: On or about March 6, 2020, and at times prior thereto, the employer allowed an employee to use a section of an extension separately. The extension ladder was not designed to be used in separate sections.
Recent events (1)
- · Z (S) $0
1926.503 A01
- Issued
- Mar 20, 2020
- Penalty
- Initial $325 · Current $325
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: On or about March 6, 2020, and at times prior thereto, employees engaged in roofing activities were not provided a fall protection training program and training, employees were exposed to an unprotected fall hazard of approximately 12 feet to the ground below.
Recent events (1)
- · Z (O) $325
1926.1060 A
- Issued
- Mar 20, 2020
- Penalty
- Initial $325 · Current $325
General-duty citation text
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards. On or about March 6, 2020, and at times prior thereto, the employer did not provide employees a ladder training program and did not provide training to remove the hazards where employees were exposed to a fall hazard of approximately 12 feet.
Recent events (1)
- · Z (O) $325
More inspections in this industry (NAICS 238160)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344678305.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.