DALLAS, TX —
OSHA Inspection: FINISHED WORK ROOFING
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of FINISHED WORK ROOFING in 6411 PEMBERTON DR, DALLAS, TX 75230 (NAICS 238160). OSHA activity number 344779517.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- FINISHED WORK ROOFING
- Site address
- 6411 PEMBERTON DR
- City
- DALLAS
- State
- TX
- ZIP
- 75230
- Mailing
- 2130 S BURLESON BLVD, BURLESON, TX 76028
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 4
- Ownership type
- A
Citations
2 citations on file for this inspection.
1926.501 B13
- Issued
- Jun 18, 2020
- Abate by
- Jul 15, 2020
- Penalty
- Initial $4,048 · Current $2,429 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. On or about June 8, 2020 Employees were installing metal roof approximately 16 feet from the lower ground level without the use of fall protection, exposing employee to a fall hazard.
Recent events (2)
- — I (S) $2428.8
- — Z (S) $4048
1926.1053 B01
- Issued
- Jun 18, 2020
- Abate by
- Jul 15, 2020
- Penalty
- Initial $4,048 · Current $2,429 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support. On or about June 8, 2020 Employees were exposed to a fall of approximately 8 feet to the lower ground level by not having the ladder extended 3 feet above the landing.
Recent events (2)
- — I (S) $2428.8
- — Z (S) $4048
More inspections at Finished Work Roofing
View Finished Work Roofing's full OSHA safety record →
More inspections in this industry (NAICS 238160)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344779517.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.