OSHA Inspection: EDUARDO COLMENERO

Issued

2020-07-23 00:00:00

Abate by

2020-08-18 00:00:00

Penalty

Initial $5398.00 · Current $2699.00 Reduced

General-duty citation text

29 CFR 1926.451(c)(1): Supported scaffolds with a height to base width (including outrigger supports, if used) ratio of more than four to one (4:1) were not restrained from tipping by guying, tying, bracing, or equivalent means, as set forth in subparagraphs (i) - (iii) of this paragraph:   (a) Southeast side of the jobsite, tubular welded scaffold system, employees were exposed to scaffold tip over/collapse hazards.

Issued

2020-07-23 00:00:00

Abate by

2020-08-18 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, structure, personnel hoist, or similar surface was not used.  Crossbraces were used as a means of access.  (a) Southeast side of the jobsite, on the  tubular welded scaffold system, employees were exposed to a fall hazard of 23-feet to the ground below.

Issued

2020-07-23 00:00:00

Abate by

2020-08-18 00:00:00

Penalty

Initial $3084.00 · Current $1542.00 Reduced

General-duty citation text

29 CFR 1926.451(h)(2): Employees working below a scaffold were not protected from falling tools, materials or equipment in accordance with the provisions of paragraphs (h)(2)(i)-(v) of this section:  (a) Southeast side of the jobsite, tubular welded scaffold employees were not protected from impact from falling or flying objects.