Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,549Inspections Most recent open 2026-08-27 Last loaded 2026-08-31

OSHA Inspection: R & R CUSTOM FRAMING

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of R & R CUSTOM FRAMING in 1824 ROYAL LAKE DR., GRAND PRAIRIE, TX 75050 (NAICS 238130). OSHA activity number 344795315.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch R & R Custom Framing for free Get an email when a new federal OSHA severe-injury report for R & R Custom Framing is published. One employer, no account, unsubscribe in one click.
Site address
1824 ROYAL LAKE DR.
City
GRAND PRAIRIE
State
TX
ZIP
75050
Mailing
6801 CRANE RD., NORTH RICHLAND HILLS, TX 76180
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
4
Ownership type
Private (A)

5 citations on file for this inspection.

1926.501 B13

Serious Gravity 5 1 instance 3 exposed
Issued
Jun 22, 2020
Penalty
Initial $2,458 · Current $1,475 Reduced
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b).        On the east side of the construction site, employees engaged in framing work without fall protection were exposed to unprotected fall hazards approximately 18 feet to the lower level.
Recent events (2)
  • · I (S) $1474.8
  • · Z (S) $2458

1926.1051 A

Serious Gravity 1 1 instance 3 exposed
Issued
Jun 22, 2020
Penalty
Initial $1,475 · Current $885 Reduced
29 CFR 1926.1051(a): Stairways or ladders were not provided at all personnel points of access where there was a break in elevation of 19 inches (48 cm) or more, and no ramp, runway, sloped embankment, or personnel hoist was provided.       On the east side of the construction site, the employer did not provide a ladder where employees could access and egress the upper landing exposing them to potential fall hazards.
Recent events (2)
  • · I (S) $885
  • · Z (S) $1475

1926.1053 B13

Serious Gravity 1 1 instance 3 exposed
Issued
Jun 22, 2020
Penalty
Initial $1,475 · Current $885 Reduced
29 CFR 1926.1053(b)(13): The top or top step of a stepladder was used as a step.       On the east side of the construction site, an employee working from the top step of a 6-foot A-frame stepladder installing framing material was exposed to a potential fall hazards.
Recent events (2)
  • · I (S) $885
  • · Z (S) $1475

1926.503 A01

Other-than-serious 1 instance 3 exposed
Issued
Jun 22, 2020
Penalty
Initial $276 · Current $166 Reduced
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:      On the east side of the construction site, employees engaged in framing work were not provided training to recognize and avoid fall hazards.
Recent events (2)
  • · I (O) $165.6
  • · Z (O) $276

1926.1060 A

Other-than-serious 1 instance 3 exposed
Issued
Jun 22, 2020
Penalty
Initial $276 · Current $166 Reduced
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards.      On the east side of the construction site, each employee was not provided a training program and training on the safe use of ladders when installing framing material exposing them to potential fall hazards.
Recent events (2)
  • · I (O) $165.6
  • · Z (O) $276

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 344795315.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.