Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,191,871Inspections Most recent open 2026-07-30 Last loaded 2026-08-03

OSHA Inspection: ROLANDO BENITO MORENTE

Unprogrammed Other inspection · Safety discipline

On , OSHA opened an unprogrammed Other safety inspection of ROLANDO BENITO MORENTE in BURTON DRIVE, LIBERTY TOWNSHIP, OH 45044 (NAICS 238160). OSHA activity number 344818927.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Rolando Benito Morente for free Get an email when a new federal OSHA severe-injury report for Rolando Benito Morente is published. One employer, no account, unsubscribe in one click.
Site address
BURTON DRIVE
City
LIBERTY TOWNSHIP
State
OH
ZIP
45044
Mailing
453 DEWDROP CIRCLE #B, CINCINNATI, OH 45240
Inspection type
Unprogrammed Other (I)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
5
Ownership type
A

3 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 1 instance 5 exposed
Issued
Sep 9, 2020
Abate by
Sep 28, 2020
Penalty
Initial $4,048 · Current $4,048
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems.  a) On or about 07/01/2020 employees were replacing an existing roof at a residential property. Employees were not utilizing a fall protection system. The height of the fall hazard was measured at 26.5 ft. from the ground.
Recent events (1)
  • · Z (S) $4048

1926.503 A01

Serious Gravity 10 1 instance 5 exposed
Issued
Sep 9, 2020
Abate by
Sep 28, 2020
Penalty
Initial $4,048 · Current $4,048
29 CFR 1926.503(a)(1): The following training provisions supplement and clarify the requirements of 1926.21 regarding the hazards addressed in Subpart M of this part. Training program. The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.   a) On or about 07/01/2020 employees have not been trained on fall protection systems and on hazards of fall, while working on heights of 26.5 ft.
Recent events (1)
  • · Z (S) $4048

1926.1053 B01

Serious Gravity 10 1 instance 5 exposed
Issued
Sep 9, 2020
Abate by
Sep 28, 2020
Penalty
Initial $4,048 · Current $4,048
29 CFR 1926.1053(b)(1): Use. The following requirements apply to the use of all ladders, including job-made ladders, except as otherwise indicated: When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.   a) On or about 07/01/2020, employees were accessing and exiting the roof by utilizing an extension ladder. The extension ladder did not extended at least 3 feet above the upper landing.
Recent events (1)
  • · Z (S) $4048

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344818927.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.