BATON ROUGE, LA ·
OSHA Inspection: OSCAR FIGUEROA, LLC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of OSCAR FIGUEROA, LLC. in 6859 JEFFERSON HWY., BATON ROUGE, LA 70806 (NAICS 236220). OSHA activity number 344881917.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- OSCAR FIGUEROA, LLC.
- Site address
- 6859 JEFFERSON HWY.
- City
- BATON ROUGE
- State
- LA
- ZIP
- 70806
- Mailing
- 3655 DONALDSON DR., BATON ROUGE, LA 70814
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236220
- Employees
- 14
- Ownership type
- Private (A)
Citations
6 citations on file for this inspection.
1926.102 A01
- Issued
- Sep 17, 2020
- Abate by
- Oct 2, 2020
- Penalty
- Initial $3,856 · Current $3,856
General-duty citation text
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles. a) On or about August 12, 2020, on the West side of the building, an employee was operating a Husqvarna MS 360 masonry saw, cutting bricks without wearing eye protection.
Recent events (1)
- · Z (S) $3856
1926.451 G01
- Issued
- Sep 17, 2020
- Abate by
- Oct 2, 2020
- Penalty
- Initial $3,856 · Current $3,856
General-duty citation text
29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet above a lower level was not protected from falling to that lower level. a) On or about August 12, 2020, on the west side of the building, employees were applying bricks to the outer shell of the building on a Scaffold at an elevated height of approximately ten (10) feet without a harness for fall protection.
Recent events (1)
- · Z (S) $3856
1926.451 G01 V
- Issued
- Sep 17, 2020
- Abate by
- Oct 2, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.451(g)(1)(v): Each employee on a walkway located within a scaffold was not protected by a guardrail system (with a minimum 200 pound toprail capacity) installed within 9.5 inches (24.1 cm) of and along at least one side of the walkway. a) On or about August 12, 2020, on the west side of the building, employees were applying bricks to the outer shell of the building on a Scaffold at an elevated height of approximately ten (10) feet without guardrails or any fall protection.
Recent events (1)
- · Z (S) $0
1926.451 G01 VI
- Issued
- Sep 17, 2020
- Abate by
- Oct 2, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.451(g)(1)(vi): Each employee performing overhand bricklaying operations from a supported scaffold was not protected from falling from all open sides and ends of the scaffold (except at the side next to the wall being laid) by the use of a personal fall arrest system or guardrail system (with minimum 200 pound toprail capacity). a) On or about August 12, 2020, on the west side of the building, employees were applying bricks to the outer shell of the building on a Scaffold at an elevated height of approximately ten (10) feet without end rails/guardrails or any fall protection.
Recent events (1)
- · Z (S) $0
1926.405 G02 IV
- Issued
- Sep 17, 2020
- Abate by
- Oct 2, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.405(g)(2)(iv): Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws. a) On or about August 12, 2020, on the West side of the building, an employee was operating a Husqarvana MS 360 Masonry Saw with strain relief not fully attached and had pulled away from receptacle.
Recent events (1)
- · Z (O) $0
1926.416 E01
- Issued
- Sep 17, 2020
- Abate by
- Oct 2, 2020
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.416(e)(1): Worn or frayed electric cords or cables were used. a) On or about August 12, 2020, on the West side of the building, employees were operating a Husqvarna MS 360 Masonry Tile Saw that was connected to an electrical power cord with damaged outer sheathing.
Recent events (1)
- · Z (O) $0
More inspections at Oscar Figueroa, LLC.
View Oscar Figueroa, LLC.'s full OSHA safety record →
More inspections in this industry (NAICS 236220)
More inspections in LA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 344881917.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.