Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: FRED WEBER REINFORCED CONCRETE PRODUCTS, INC.

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of FRED WEBER REINFORCED CONCRETE PRODUCTS, INC. in 12950 GRAVOIS ROAD, SAINT LOUIS, MO 63127 (NAICS 327332). OSHA activity number 345025803.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Fred Weber Reinforced Concrete Products, INC. — free Get an email when a new federal OSHA severe-injury report for Fred Weber Reinforced Concrete Products, INC. is published. One employer, no account, unsubscribe in one click.
Site address
12950 GRAVOIS ROAD
City
SAINT LOUIS
State
MO
ZIP
63127
Mailing
12950 GRAVOIS ROAD, SAINT LOUIS, MO 63127
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
327332
Employees
43
Ownership type
A

5 citations on file for this inspection.

1910.28 B06 I

Serious Gravity 10 1 instance 1 exposed
Issued
Jan 27, 2021
Penalty
Initial $9,446 · Current $4,723 Reduced
Each employee less than 4 feet (1.2 m) above dangerous equipment was not protected from falling into or onto the dangerous equipment by a guardrail system or a travel restraint system, unless the equipment was covered or guarded to eliminate the hazard. On or about 11/03/2020, Fred Weber Reinforced Concrete Products, Inc. had not ensured employees working on or near a Besser, Model A-48 BiDi, concrete pipe manufacturing machine were protected from falling on a pallet turner located in a floor opening on a rotating table.
Recent events (2)
  • — I (S) $4723
  • — Z (S) $9446

1910.28 B07 IV

Deleted Serious Gravity 10 1 instance 1 exposed
Issued
Jan 27, 2021
Penalty
Initial $0 · Current $0
29 CFR  1910.28(b)(7)(iv):(iv)  Openings. The employer did not ensure that each employee on a walking-working surface near an opening, including one with a chute attached, where the inside bottom edge of the opening was less than 39 inches (99 cm) above that walking-working surface and the outside bottom edge of the opening is 4 feet (1.2 m) or more above a lower level was protected from falling by the use of personal fall arrest systems. On or about 11/03/2020, Fred Weber Reinforced Concrete Products, Inc. had not ensured employees working on or near a Besser, Model A-48 BiDi, concrete pipe manufacturing machine were protected from falling through a floor opening on the machine's rotating table.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.147 C04 I

Other-than-serious Gravity 5 1 instance 2 exposed
Issued
Jan 27, 2021
Penalty
Initial $5,735 · Current $0 Reduced
29 CFR  1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees are engaged in the activities covered by this section. On or about 11/03/2020, Fred Weber Reinforced Concrete Products, Inc. had not developed, documented and utilized an energy control procedure to control of potentially hazardous energy while repairing a pallet lifting fixture attached to Gorbel 500 LBS. hoist.
Recent events (2)
  • — I (O) $0
  • — Z (S) $5735

1910.147 C04 II B

Deleted Serious Gravity 5 2 instances 2 exposed
Issued
Jan 27, 2021
Penalty
Initial $0 · Current $0
29 CFR  1910.147(c)(4)(ii)(B): Specific procedural steps for shutting down, isolating, blocking and securing machines or equipment to control hazardous energy.  On or about 11/03/2020, Fred Weber Reinforced Concrete Products, Inc. had not developed, documented and utilized energy control procedures with specific steps for shutting down, isolating, and securing hazardous energy for various equipment/machines to include, but not limited to the following equipment: a)	Besser, Model A-48 BiDi, concrete pipe manufacturing machine b)	A pallet lifting fixture attached to Gorbel 500 LBS. hoist
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.147 C06 I

Other-than-serious Gravity 10 2 instances 2 exposed
Issued
Jan 27, 2021
Penalty
Initial $9,446 · Current $0 Reduced
29 CFR  1910.147(c)(6)(i):The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirements of this standard were being followed. On or about 11/03/2020, Fred Weber Reinforced Concrete Products, Inc. had not conducted periodic inspections of the energy control procedures at least annually to ensure the requirements of this standard to include subparagraphs (A)-(D) were being followed.
Recent events (2)
  • — I (O) $0
  • — Z (S) $9446

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345025803.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.