SOUTH LAKE, TX —
OSHA Inspection: CUSTOM CONSTRUCTION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of CUSTOM CONSTRUCTION in 312 MATTHEWS, SOUTH LAKE, TX 76092 (NAICS 238130). OSHA activity number 345086383.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- CUSTOM CONSTRUCTION
- Site address
- 312 MATTHEWS
- City
- SOUTH LAKE
- State
- TX
- ZIP
- 76092
- Mailing
- 1001 CR 4526, WHITEWRIGHT, TX 75491
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 7
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.100 A
- Issued
- Jan 8, 2021
- Penalty
- Initial $1,475 · Current $885 Reduced
General-duty citation text
29 CFR 1926.100(a):Employees working in areas where there is a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns, shall be protected by protective helmets. On or about January 5, 2021, at a residential framing jobsite, two employees worked below an employee working from above without head protection. The employees were exposed to overhead head injuries by struck-by hazards.
Recent events (2)
- — I (S) $885
- — Z (S) $1475
1926.501 B13
- Issued
- Jan 8, 2021
- Penalty
- Initial $2,458 · Current $1,475 Reduced
General-duty citation text
29 CFR 1926.501(b)(13):"Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. On or about January 5, 2021 , and at times prior thereto, the employer did not ensure framing employees were protected from fall hazards. Employees were exposed to a fall hazard of approximately 10 feet to the ground below.
Recent events (2)
- — I (S) $1474.8
- — Z (S) $2458
1926.1053 B01
- Issued
- Jan 8, 2021
- Penalty
- Initial $2,458 · Current $1,475 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1):When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support. On or about January 5, 2020, and at times prior thereto, at�a residential construction job�site, an employee performing�framing work climbed a job-made ladder to access and egress the work�areas�with�the ladder not extended at least 3 feet above the upper landing surface. An employee was exposed the to a fall hazards up to�10 feet to the ground below.
Recent events (2)
- — I (S) $1474.8
- — Z (S) $2458
1926.503 A01
- Issued
- Jan 8, 2021
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1):The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. On or about January 5, 2021, and at times prior thereto, a framing employee working from the top plate of a residential construction project was not provided fall protection training. The employee was exposed to a fall hazard of approximately 10 feet to the ground below.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1926.1060 A
- Issued
- Jan 8, 2021
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1060(a):The employer shall provide a training program for each employee using ladders and stairways, as necessary. The program shall enable each employee to recognize hazards related to ladders and stairways, and shall train each employee in the procedures to be followed to minimize these hazards. On or about January 5, 2021, and at times prior thereto, at a residential construction job site, the employer did not provide ladder training. An employee performing framing work climbed extension ladder to access that did not extend three feet prior to use exposing the employees to fall hazards of up to 10 feet.
Recent events (2)
- — I (O) $0
- — Z (O) $0
More inspections at Custom Construction
View Custom Construction's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345086383.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.