Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: ALLEGRO HOMES, LLC

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of ALLEGRO HOMES, LLC in TREASURE ISLAND UNION SELF STORAGE US 22 EAST & VAUXHALL ROAD, UNION, NJ 07083 (NAICS 238140). OSHA activity number 345293724.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Allegro Homes, LLC — free Get an email when a new federal OSHA severe-injury report for Allegro Homes, LLC is published. One employer, no account, unsubscribe in one click.
Establishment
ALLEGRO HOMES, LLC
Site address
TREASURE ISLAND UNION SELF STORAGE US 22 EAST & VAUXHALL ROAD
City
UNION
State
NJ
ZIP
07083
Mailing
1849 NEW HAMPSHIRE AVE., TOMS RIVER, NJ 08755
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
12
Ownership type
A

7 citations on file for this inspection.

1926.102 A01

Serious Gravity 5 1 instance 2 exposed
Issued
Oct 18, 2021
Penalty
Initial $4,681 · Current $2,500 Reduced
29 CFR  1926.102(a)(1):The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation.  a. 1650-1660 US 22 East and Vauxhall Road, Union, NJ - Treasure Island Storage  The employer did not ensure that employees used eye and face protection.  Employees engaged in masonry activities used a Husqvarna K770 14 in. Cut-Off Saw to dry cut block without any means of facial or eye protection.  Violation observed on or about May 6, 2021
Recent events (3)
  • — J (S) $2500
  • — C (S) $4681
  • — Z (S) $4681

1926.451 E01

Serious Gravity 5 1 instance 3 exposed
Issued
Oct 18, 2021
Penalty
Initial $4,681 · Current $2,500 Reduced
29 CFR  1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, structure, personnel hoist, or similar surface was not used.  Cross braces were used as a means of access:    a. 1650-1660 US 22 East & Vauxhall Rd., Union, NJ - Treasure Island Storage - Union  The employer did not ensure safe access to scaffold platforms when the platform was greater than two feet above the point of access.  Employees engaged in masonry activities working from a two tier, welded tubular frame scaffold used the cross braces and frames to access the scaffold platform.  Violation observed on or about May 6, 2021
Recent events (3)
  • — J (S) $2500
  • — C (S) $4681
  • — Z (S) $4681

1926.451 F03

Serious Gravity 10 1 instance 3 exposed
Issued
Oct 18, 2021
Penalty
Initial $5,461 · Current $3,000 Reduced
29 CFR 1926.451(f)(3): Scaffolds and scaffold components were not inspected for visible defects by a competent person before each work shift, and after any occurrence which could affect a scaffold's structural integrity:   a. 1650-1660 US 22 East & Vauxhall Rd., Union, NJ - Treasure Island Storage - Union  The employer did not ensure the scaffold was inspected prior to use. Employees engaged in masonry activities worked from a two tier, welded tubular frame scaffold, with visible defects that included, but were not limited to, unstable footings, missing guard rails when required, and a safe means of access, that affected the structural integrity of the scaffold, which had not been inspected by the competent person prior to use by the employees.   Violation observed on or about May 6, 2021
Recent events (3)
  • — J (S) $3000
  • — C (S) $5461
  • — Z (S) $5461

1926.1153 C01

Serious Gravity 10 1 instance 3 exposed
Issued
Oct 18, 2021
Penalty
Initial $5,461 · Current $3,000 Reduced
29 CFR 1926.1153(c)(1): Specified exposure control methods. For each employee engaged in a task identified on Table 1, the employer shall fully and properly implement the engineering controls, work practices, and respiratory protection specified for the task on Table 1, unless the employer assesses and limits the exposure of the employee to respirable crystalline silica in accordance with paragraph (d) of this section:   a. 1650-1660 US 22 East & Vauxhall Rd., Union, NJ - Treasure Island Storage - Union  The employer failed to fully and properly implement engineering controls, work practices, and/or respiratory protection for employees exposed to respirable crystalline silica. Employees engaged in masonry activities used a Husqvarna K770 handheld cutoff saw to dry cut concrete block. The exposure control methods implemented by employer were not effective as no wetting was used during cutting operations which created clouds of silica dust. The integrated water delivery system for the handheld saw was not being utilized.  Violation observed on or about May 6, 2021
Recent events (3)
  • — J (S) $3000
  • — C (S) $5461
  • — Z (S) $5461

1926.1153 D02 I

Serious Gravity 10 1 instance 3 exposed
Issued
Oct 18, 2021
Penalty
Initial $0 · Current $0
29 CFR  1926.1153(d)(2)(i): The employer did not assess the exposure of each employee who was or may reasonably be expected to be exposed to respirable crystalline silica at or above the action level in accordance with either the performance option in paragraph (d)(2)(ii) or the scheduled monitoring option in paragraph (d)(2)(iii) of this section:   a. 1650-1660 US 22 East & Vauxhall Rd., Union, NJ - Treasure Island Storage - Union  The employer failed to fully and properly assess engineering controls, work practices, and/or respiratory protection for employees were reasonable expected to be exposed to respirable crystalline silica. Employees engaged in masonry activities used a Husqvarna K770 handheld cutoff saw to dry cut concrete block, where exposure control methods implemented by employer were not effective as no wetting was used during cutting operations which created clouds of silica dust.  Violation observed on or about May 6, 2021
Recent events (3)
  • — J (S) $0
  • — C (S) $0
  • — Z (S) $0

1926.451 C02 I

Willful Gravity 10 1 instance 3 exposed
Issued
Oct 18, 2021
Penalty
Initial $54,613 · Current $33,500 Reduced
29 CFR  1926.451(c)(2)(i):Footings were not level, sound, rigid, and capable of supporting the loaded scaffold without settling or displacement:  a. 1650-1660 US 22 East & Vauxhall Rd., Union, NJ - Treasure Island Storage - Union  The employer did not ensure that welded tubular frame scaffold was erected in a manner to support the loaded scaffold.  Employees engaged in masonry activities worked from a scaffold where the footings were placed on planks supported on blocks that were not capable of supporting the scaffold without settling or displacement.  Violation observed on or about May 6, 2021
Recent events (3)
  • — J (W) $33500
  • — C (W) $54613
  • — Z (W) $54613

1926.451 G01 VII

Willful Gravity 10 1 instance 1 exposed
Issued
Oct 18, 2021
Penalty
Initial $54,613 · Current $33,500 Reduced
29 CFR  1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.  a. 1650-1660 US 22 East and Vauxhall Road, Union, NJ - Treasure Island Storage  The  employer did not ensure that any means of fall protection was provided on sides and open ends of the scaffold.  Employees engaged in masonry activities worked from a welded tubular frame scaffold, where the working platform was greater than 10 feet, and the working platform was not protected by a guardrail system that included end rails to the materials platform or the working side bracket platform.   Violation observed on or about May 6, 2021
Recent events (3)
  • — J (W) $33500
  • — C (W) $54613
  • — Z (W) $54613

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345293724.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.