POWELL, OH —
OSHA Inspection: GE CARPENTRY LLC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of GE CARPENTRY LLC in 4367 KATHRYN CROSSING DR LOT 3916, POWELL, OH 43065 (NAICS 238130). OSHA activity number 345368120.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- GE CARPENTRY LLC
- Site address
- 4367 KATHRYN CROSSING DR LOT 3916
- City
- POWELL
- State
- OH
- ZIP
- 43065
- Mailing
- 2284 ONTARIO ST, COLUMBUS, OH 43211
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 4
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.20 B01
- Issued
- Sep 10, 2021
- Abate by
- Sep 30, 2021
- Penalty
- Initial $2,926 · Current $2,926
General-duty citation text
29 CFR 1926.20(b)(1): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part. a. On or about June 17, 2021, the employer did not initiate and maintain an effective safety and health program to ensure hazard detection and correction while an employee installed framing lumber on top of the exterior wall of a new build residential home. The employee was exposed to a fall hazard of 17 feet 3 inches at the top of the exterior wall to the ground level and 9 feet 3 inches towards the interior OSB sheathing floor as a result.
Recent events (1)
- — Z (S) $2926
1926.21 B02
- Issued
- Sep 10, 2021
- Abate by
- Sep 30, 2021
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.21(b)(2): The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury. a. On or about June 17, 2021, the employer did not instruct employees on the avoidance of unsafe conditions while an employee installed framing lumber on top of the exterior wall of a new build residential home. The employee was exposed to a fall hazard of 17 feet 3 inches at the top of the exterior wall to the ground level and 9 feet 3 inches towards the interior OSB sheathing floor as a result.
Recent events (1)
- — Z (S) $0
1926.501 B13
- Issued
- Sep 10, 2021
- Abate by
- Sep 30, 2021
- Penalty
- Initial $4,096 · Current $4,096
General-duty citation text
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems. a. On or about June 17, 2021, the employer failed to ensure that an employee was protected from falling when framing work was done on top of an exterior wall of a new build residential home. As a result the employee was exposed to fall hazards at 9 feet 3 inches to the OSB sheathing floor level and 17 feet 3 inches to the ground level respectively.
Recent events (1)
- — Z (S) $4096
1926.1053 B04
- Issued
- Sep 10, 2021
- Abate by
- Oct 6, 2021
- Penalty
- Initial $2,926 · Current $2,926
General-duty citation text
29 CFR 1926.1053(b)(4): Ladders shall be used only for the purpose for which they were designed. a. On or about June 17, 2021, the employer did not ensure that the ladder at the worksite location was used in accordance for which it was designed when an employee used the ladder to access the elevated working surface.
Recent events (1)
- — Z (S) $2926
More inspections in this industry (NAICS 238130)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345368120.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.