Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,549Inspections Most recent open 2026-08-27 Last loaded 2026-08-31

OSHA Inspection: PARCO ENVIRONMENTAL INC.

Fatality or catastrophe inspection · Safety discipline

On , OSHA opened a fatality or catastrophe safety inspection of PARCO ENVIRONMENTAL INC. in 1450 SPILLMAN DR PRESS FORGE BUILDING, BETHLEHEM, PA 18015 (NAICS 561210). OSHA activity number 345412134.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Parco Environmental INC. for free Get an email when a new federal OSHA severe-injury report for Parco Environmental INC. is published. One employer, no account, unsubscribe in one click.
Site address
1450 SPILLMAN DR PRESS FORGE BUILDING
City
BETHLEHEM
State
PA
ZIP
18015
Mailing
6200 RIVERSIDE DR, CLEVELAND, OH 44135
Inspection type
Fatality or catastrophe (M)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
561210
Employees
4
Ownership type
Private (A)

4 citations on file for this inspection.

1926.501 B10

Serious Gravity 10 1 instance 3 exposed
Issued
Dec 22, 2021
Abate by
Jan 7, 2022
Penalty
Initial $13,653 · Current $13,653
29 CFR  1926.501(b)(10):Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.  Or, on roofs 50-feet (15.25 m) or less in width, each employee was not protected by use of a monitoring system.  a) North side roof of press forge, 4 bay, over center track door - On or about July 11, 2021, employees removing old roofing material were not protected from falling more than 40 feet to the ground.
Recent events (2)
  • · I (S) $13653
  • · Z (S) $13653

1926.760 A01

Deleted Serious Gravity 10 1 instance 3 exposed
Issued
Dec 22, 2021
Abate by
Jan 7, 2022
Penalty
Initial $0 · Current $0
29 CFR  1926.760(a)(1):Each employee engaged in a steel erection activity who is on a walking/working surface with an unprotected side or edge more than 15 feet (4.6 m) above a lower level was not protected from fall hazards by guardrail systems, safety net systems, personal fall arrest systems, positioning device systems, or fall restraint systems.  a) North side roof of press forge, 4 bay, over center track door - On or about July 11, 2021, employees installing steel roof decking were not protected from falling more than 40 feet to the ground.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.503 A01

Serious Gravity 10 1 instance 4 exposed
Issued
Dec 22, 2021
Abate by
Jan 12, 2022
Penalty
Initial $13,653 · Current $13,653
29 CFR  1926.503(a)(1):The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a) North side roof of press forge, 4 bay, center track door - On or about July 11, 2021, employees removing old roofing material were exposed to a fall hazard over 40 feet had not been trained in recognition of fall hazards or use, application, installation, or evaluation of necessary fall protection to minimize fall hazards.
Recent events (2)
  • · I (S) $13653
  • · Z (S) $13653

1926.761 B

Serious Gravity 10 1 instance 3 exposed
Issued
Dec 22, 2021
Abate by
Jan 7, 2022
Penalty
Initial $0 · Current $0
29 CFR  1926.761(b):Fall hazard training. The employer did not train each employee exposed to a fall hazard in accordance with the requirements of this section. The employer did not institute a training program and ensure employee participation in the program:  a) North side roof of press forge, 4 bay, center track door - On or about July 11, 2021, employees installing steel decking on the roof were exposed to a fall hazard over 40 feet but had not been trained in recognition of fall hazards or use, application, installation, or evaluation of necessary fall protection to minimize fall hazards.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

View Parco Environmental INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 345412134.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.