WARWICK, RI —
OSHA Inspection: EMC ROOFING & REMODELING, LLC
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of EMC ROOFING & REMODELING, LLC in 1060 TOLL GATE ROAD, WARWICK, RI 02886 (NAICS 238160). OSHA activity number 345510507.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- EMC ROOFING & REMODELING, LLC
- Site address
- 1060 TOLL GATE ROAD
- City
- WARWICK
- State
- RI
- ZIP
- 02886
- Mailing
- 3 CASIE LANE, PEPPERELL, MA 01463
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 7
- Ownership type
- A
Citations
3 citations on file for this inspection.
1926.502 F02 II
- Issued
- Nov 16, 2021
- Abate by
- Nov 23, 2021
- Penalty
- Initial $2,926 · Current $2,926
General-duty citation text
29 CFR 1926.502(f)(2)(ii): The rope, wire, or chain was not rigged and supported in such a way that its lowest point (including sag) was no less than 34 inches (.9 m) from the walking/working surface and its highest point was no more than 39 inches (1.0 m) from the walking/working surface: (a) On the west side of the building: On or about 9/2/2021, the employer did not ensure that roof warning lines were rigged between 34 and 39 inches in height.
Recent events (1)
- — Z (S) $2926
1926.503 A01
- Issued
- Nov 16, 2021
- Abate by
- Dec 10, 2021
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: (a) On the west side of the building: On or about 9/2/2021, the employer did not provide training to an employee who was exposed to a fall hazard of approximately 13' 11".
Recent events (1)
- — Z (S) $0
1926.1053 B01
- Issued
- Nov 16, 2021
- Penalty
- Initial $2,926 · Current $2,926
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: (a) At the worksite: On or about 9/2/2021, an extension ladder was used by employees to access the roof and the ladder side rails did not extended at least 3 feet above the upper level surface.
Recent events (1)
- — Z (S) $2926
More inspections in this industry (NAICS 238160)
More inspections in RI
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345510507.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.