OSHA Inspection: LAMI WOOD PRODUCTS CORPORATION

Issued

2021-10-27 00:00:00

Abate by

2021-11-23 00:00:00

Penalty

Initial $6827.00 · Current $4096.00 Reduced

General-duty citation text

29 CFR  1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section:  JOB SITE: 1 Lami Industrial Drive, Saint Charles, MO 63366, on or about 10/6/2021, the employer failed to develop, document, and utilize procedures for the control of potentially hazardous energy on equipment including, but not limited to:  1)  Midwest Automation Saw 135M, Model: CS5840, S/N: 2000-0201  2)  Router TMPES, S/N: A60577 3)  Marble/Stone Cutter, S/N: 3-06-2031

Issued

2021-10-27 00:00:00

Abate by

2021-11-23 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.147(c)(6)(i): The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirement of this standard were being followed:  JOB SITE: 1 Lami Industrial Drive, Saint Charles, MO 63366, on or about 10/6/2021, the employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedures and the requirements of this standard were being followed, on equipment including, but not limited to:  1)  Midwest Automation Saw 135M, Model: CS5840, S/N: 2000-0201  2)  Router TMPES, S/N: A60577 3)  Marble/Stone Cutter, S/N: 3-06-2031

Issued

2021-10-27 00:00:00

Abate by

2021-11-23 00:00:00

Penalty

Initial $6827.00 · Current $4096.00 Reduced

General-duty citation text

29 CFR  1910.212(a)(3)(ii):Point(s) of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle(s):  JOB SITE: 1 Lami Industrial Drive, St. Charles, MO  63304, on or about 10/6/2021, the employees are permitted to operate equipment without guards, exposing themselves to amputation hazards.  The employees are not protected from having any part of their body in the danger zone(s) during operating cycle(s) with the following cutting equipment.  1)  Midwest Automation 135M, Model: CS5840, S/N: 2000-0201 2)  Router TMPES, S/N: A60577 3)  Marble/Stone Cutter, S/N: 3-06-2031