Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: ALESY CONSTRUCTION LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of ALESY CONSTRUCTION LLC in LOTS 112 & 113 CATAMARAN COURT, ALPHARETTA, GA 30009 (NAICS 238170). OSHA activity number 345638621.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Alesy Construction LLC — free Get an email when a new federal OSHA severe-injury report for Alesy Construction LLC is published. One employer, no account, unsubscribe in one click.
Site address
LOTS 112 & 113 CATAMARAN COURT
City
ALPHARETTA
State
GA
ZIP
30009
Mailing
1220 SUMMIT POINT LANE, SNELLVILLE, GA 30078
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238170
Employees
4
Ownership type
A

2 citations on file for this inspection.

1926.451 G01 VII

Serious Gravity 10 1 instance 2 exposed
Issued
Feb 4, 2022
Penalty
Initial $4,351 · Current $4,351
29 CFR  1926.451(g)(1)(vii):Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.  New townhome construction located on Lots #112 and #113 Catamaran Court, Alpharetta, GA 30009, Rear side: On or about 11/16/2021, the employer exposed employees to fall hazards of approximately 30-feet to the lower ground level, in that a fall protection system was not provided while employees were engaged in siding installation activities using a pump jack scaffold system.
Recent events (1)
  • — Z (S) $4351

1926.1153 C01

Serious Gravity 5 1 instance 3 exposed
Issued
Feb 4, 2022
Penalty
Initial $3,108 · Current $3,108
29 CFR 1926.1153(c)(1): For each employee engaged in a task identified on Table 1, the employer did not fully and properly implement the engineering controls, work practices, and respiratory protection specified for the task on Table 1, unless the employer assesses and limits the exposure of the employee to respirable crystalline silica in accordance with paragraph (d) of this section:  New townhome construction located on Lots #112 and #113 Catamaran Court, Alpharetta, GA 30009, Rear side at cut bench: On or about 11/16/2021, the employer exposed employees to silica exposure while cutting Hardie Plank Siding, in that the DeWalt (Model DWE575) 7-1/4-inch circular saw used to cut siding was not provided with the vacuum system (Engineering Control) needed to reduce exposure of the silica dust created while cutting fiber cement siding.
Recent events (1)
  • — Z (S) $3108

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345638621.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.