MANSFIELD, MA —
OSHA Inspection: NATIONAL LUMBER DIVISION OF BUILDERS FIRSTSOURCE INCORPORATED
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of NATIONAL LUMBER DIVISION OF BUILDERS FIRSTSOURCE INCORPORATED in 71 MAPLE STREET, MANSFIELD, MA 02048 (NAICS 444110). OSHA activity number 345711485.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Site address
- 71 MAPLE STREET
- City
- MANSFIELD
- State
- MA
- ZIP
- 02048
- Mailing
- P.O. BOX 25178 ATTN: ACCOUNTS PAYABLE DEPT., LEHIGH VALLEY, PA 18002
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 444110
- Employees
- 100
- Ownership type
- A
Citations
7 citations on file for this inspection.
1910.28 B01 I
- Issued
- Jun 6, 2022
- Abate by
- Jul 27, 2022
- Penalty
- Initial $10,360 · Current $6,000 Reduced
General-duty citation text
29 CFR 1910.28(b)(1)(i): Except as provided elsewhere in this section, the employer did not ensure that each employee on a walking-working surface with an unprotected side or edge that is 4 feet (1.2 m) or more above a lower level was protected from falling: Engineered Wood Products Dept.: A guardrail was not provided at the open side of the gluing area floor and exposed workers to fall hazards of greater than 4-feet.
Recent events (3)
- — F (S) $6000
- — C (S) $10360
- — Z (S) $10360
1910.28 B15
- Issued
- Jun 6, 2022
- Abate by
- Jul 27, 2022
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.28(b)(15): Open-sided floors and/or platforms four feet or more above adjacent floor or ground level were not guarded with standard railings (or equivalent): Engineered Wood Products Dept. : The wall opening next to the conveyor after the gluer was not covered and exposed employees to fall hazards of greater than 4-feet.
Recent events (3)
- — F (S) $0
- — C (S) $0
- — Z (S) $0
1910.36 G02
- Issued
- Jun 6, 2022
- Abate by
- Jul 27, 2022
- Penalty
- Initial $6,215 · Current $1,000 Reduced
General-duty citation text
29 CFR 1910.36(g)(2): An exit access must be at least 28 inches (71.1 cm) wide at all points. Where there is only one exit access leading to an exit or exit discharge, the width of the exit and exit discharge must be at least equal to the width of the exit access. Engineered Wood Dept.: The section of the exit access between the glue conveyor and the wall near it was not 28-inches wide.
Recent events (3)
- — F (O) $1000
- — C (S) $6215
- — Z (S) $6215
1910.147 C04 I
- Issued
- Jun 6, 2022
- Penalty
- Initial $14,502 · Current $9,000 Reduced
General-duty citation text
29 CFR 1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section: Engineered Wood Products Dept. : Lockout tagout energy control procedures were not utilized while employees performed servicing activities such as, but not limited to, reinstalling conveying chains back onto their nylon tracks while the conveyor was running.
Recent events (3)
- — F (S) $9000
- — C (S) $14502
- — Z (S) $14502
1910.147 C07 I A
- Issued
- Jun 6, 2022
- Abate by
- Jul 27, 2022
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.147(c)(7)(i)(A): Authorized employee(s) did not receive training in the recognition of applicable hazardous energy sources, the type and magnitude of the energy available in the workplace, and the methods and means necessary for energy isolation and control. Engineered Wood Products Dept.: Operators of the cutoff saw were not trained to utilize lockout tagout energy control procedures while performing servicing activities such as placing the conveying chains back into their nylon tracks.
Recent events (3)
- — F (S) $0
- — C (S) $0
- — Z (S) $0
1910.212 A01
- Issued
- Jun 6, 2022
- Abate by
- Nov 14, 2022
- Penalty
- Initial $14,502 · Current $9,000 Reduced
General-duty citation text
29 CFR 1910.212(a)(1): Machine guarding was not provided to protect operator(s) and other employees from hazard(s) created by POINT OF OPERATION, INGOING NIP POINT, ROTATING PARTS AND/OR FLYING CHIPS OR SPARKS: Engineered Wood Products: 1) The conveying chains of the jump chains that bring boards from the Hundegger Machine to the operator and laborers were not adequately guarded. 2) Pinch-points are created at the jump chains that bring boards from the Hundegger to the operator and laborers when the emergency stop is activated and the conveying chains drop.
Recent events (3)
- — F (S) $9000
- — C (S) $14502
- — Z (S) $14502
1904.39 A02
- Issued
- Jun 6, 2022
- Abate by
- Jul 27, 2022
- Penalty
- Initial $10,360 · Current $0 Reduced
General-duty citation text
29 CFR 1904.39(a)(2): The employer did not report within 24-hours a work-related incident resulting in in-patient hospitalization, amputation or the loss of an eye. Worksite: The employer did not report an amputation injury to OSHA within 24-hours.
Recent events (3)
- — F (O) $0
- — C (O) $10360
- — Z (O) $10360
More inspections in this industry (NAICS 444110)
More inspections in MA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345711485.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.