WETHERSFIELD, CT ·
OSHA Inspection: CARBONE MASONRY AND RESTORATION LLC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of CARBONE MASONRY AND RESTORATION LLC in 1912-14 BERLIN TURNPIKE, WETHERSFIELD, CT 06109 (NAICS 238140). OSHA activity number 346202385.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- CARBONE MASONRY AND RESTORATION LLC
- Site address
- 1912-14 BERLIN TURNPIKE
- City
- WETHERSFIELD
- State
- CT
- ZIP
- 06109
- Mailing
- 326 GRISWOLD ROAD, WETHERSFIELD, CT 06109
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238140
- Employees
- 6
- Ownership type
- Private (A)
Citations
4 citations on file for this inspection.
1926.300 B01
- Issued
- Jan 3, 2023
- Penalty
- Initial $2,486 · Current $2,000 Reduced
General-duty citation text
29 CFR 1926.300(b)(1):Power operated tool(s), designed to accommodate guards, were not equipped with such guards when in use: On or about September 7, 2022, an employee was using a powered hand grinder to grind off burrs and rust from angle iron and the guard was not in use.
Recent events (2)
- · I (S) $2000
- · Z (S) $2486
1926.404 B01 II
- Issued
- Jan 3, 2023
- Penalty
- Initial $3,108 · Current $2,000 Reduced
General-duty citation text
29 CFR 1926.404(b)(1)(ii):On a construction site, where an assured equipment grounding program was not utilized, all 120-volt, single-phase, 15 and 20 ampere receptacle outlets which were not a part of the permanent wiring of the building or structure and which are in use by employees did not have approved ground fault circuit interrupers for personal protection. On or about September 7, 2022, an employee was using a electrically powered hand grinder to grind off burrs and rust from pieces of angle iron and the grinder was energized and in use without any GFCI protection.
Recent events (2)
- · I (S) $2000
- · Z (S) $3108
1926.405 G02 IV
- Issued
- Jan 3, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.405(g)(2)(iv):Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws: On or about September 7, 2022, an employee was using a electrically powered hand grinder to grind off burrs and rust from pieces of angle iron and the extension cord in use had strain relief damage.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1926.701 B
- Issued
- Jan 3, 2023
- Penalty
- Initial $3,108 · Current $2,000 Reduced
General-duty citation text
29 CFR 1926.701(b):All protruding reinforcing steel, onto and/or into which employees could fall, was not guarded to eliminate the hazard of impalement: On or about September 7, 2022, employees including the foreman were working at and near unguarded rebar.
Recent events (2)
- · I (S) $2000
- · Z (S) $3108
More inspections in this industry (NAICS 238140)
More inspections in CT
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 346202385.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.