PLAIN CITY, OH —
OSHA Inspection: JERRY M. TURNBAUGH
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of JERRY M. TURNBAUGH in 9062 MITCHELL CROSSING LOT 5, PLAIN CITY, OH 43064 (NAICS 238130). OSHA activity number 346232937.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- JERRY M. TURNBAUGH
- Site address
- 9062 MITCHELL CROSSING LOT 5
- City
- PLAIN CITY
- State
- OH
- ZIP
- 43064
- Mailing
- 263 NORTH CEDAR STREET, NEWARK, OH 43055
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 4
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.102 A01
- Issued
- Dec 22, 2022
- Abate by
- Jan 20, 2023
- Penalty
- Initial $2,735 · Current $2,735
General-duty citation text
29 CFR 1926.102(a)(1):The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation. a. Located at 9062 Mitchell Crossing, Plain City, OH 43064: On or about September 20, 2022, the employer failed to ensure that each employee was protected from flying wood particles and nails with the use of eye protection while operating pneumatic nail guns to fasten framing materials together.
Recent events (1)
- — Z (S) $2735
1926.501 B13
- Issued
- Dec 22, 2022
- Abate by
- Jan 20, 2023
- Penalty
- Initial $31,906 · Current $31,906
General-duty citation text
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems. a. The employer does not protect each employee from the hazard of falling by the use of fall protection systems. This most recently occurred on September 20, 2022 on the job site located at 9062 Mitchell Crossing, Plain City, OH 43064. The employer failed to ensure that employees who were performing framing work on the roof of a new build residential home were protected from fall hazards while sheathing and framing the roof, which exposed them to a fall hazard in excess of 6 feet. Jerry M. Turnbaugh was previously cited for a violation of this Occupational Safety and Health standard, CFR 1926.501(b)(13), which was contained in OSHA inspection number 1292941, citation number 2, item number 1, and was affirmed as a final order on May 24, 2019, with respect to a workplace located at 7566 Kelly Drive, Dublin, OH 43016.
Recent events (1)
- — Z (W) $31906
1926.503 A01
- Issued
- Dec 22, 2022
- Abate by
- Jan 20, 2023
- Penalty
- Initial $31,906 · Current $31,906
General-duty citation text
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. a. The employer does not protect each employee from the hazards of falling by the use of a training program that enables each employee to recognize the hazards of falling. This most recently occurred on September 20, 200 on the job site located at 9062 Mitchell Crossing, Plain City, OH 43064. The employer failed to provide a training program for employees exposed to hazards while performing residential construction framing at heights exceeding 6 feet. Jerry M. Turnbaugh was previously cited for a violation of this Occupational Safety and Health standard or its equivalent, CFR 1926.503(c)(1), which was contained in OSHA inspection number 1292941, citation number 2, item number 2, and was affirmed as a final order on May 24, 2019, with respect to a workplace located at 7566 Kelly Drive, Dublin, OH 43016.
Recent events (1)
- — Z (W) $31906
1926.20 B01
- Issued
- Dec 22, 2022
- Abate by
- Jan 20, 2023
- Penalty
- Initial $9,571 · Current $9,571
General-duty citation text
29 CFR 1926.20(b)(1): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part. a. Located at 9062 Mitchell Crossing, Plain City, OH 43064: On or about September 20, 2022, the employer failed to develop and maintain an effective safety and health program to ensure that fall and struck-by hazards associated with residential construction were identified and corrected on site. Jerry M. Turnbaugh was previously cited for a violation of this Occupational Safety and Health standard, 29 CFR 1926.20(b)(1), which was contained in OSHA inspection number 1292941, citation number 1, item number 1, and was affirmed as a final order on May 24, 2019, with respect to a workplace located at 7566 Kelly Drive, Dublin, OH 43016.
Recent events (1)
- — Z (R) $9571
More inspections at Jerry M. Turnbaugh
View Jerry M. Turnbaugh's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346232937.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.