CINCINNATI, OH —
OSHA Inspection: MIGUEL ISLAS
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of MIGUEL ISLAS in 610 NORTHLAND BLVD, CINCINNATI, OH 45240 (NAICS 238160). OSHA activity number 346286180.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MIGUEL ISLAS
- Site address
- 610 NORTHLAND BLVD
- City
- CINCINNATI
- State
- OH
- ZIP
- 45240
- Mailing
- 6950 SHENANDOAH DR., FLORENCE, KY 41042
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 3
- Ownership type
- A
Citations
2 citations on file for this inspection.
1926.501 B10
- Issued
- Nov 1, 2022
- Penalty
- Initial $4,351 · Current $4,351
General-duty citation text
29 CFR 1926.501(b)(10):"Roofing work on Low-slope roofs." Except as otherwise provided in paragraph (b) of this section, each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Or, on roofs 50-feet (15.25 m) or less in width (see Appendix A to subpart M of this part), the use of a safety monitoring system alone [i.e. without the warning line system] is permitted. (a) On October 17, 2022, located on a low-pitch commercial roof, employees were exposed to a fall hazard while installing shingles at the edge of the roof and not utilizing a fall protection system. The potential fall height was measured to be 9 feet with a roof pitch of 4/12.
Recent events (1)
- — Z (S) $4351
1926.502 A02
- Issued
- Nov 1, 2022
- Penalty
- Initial $4,351 · Current $4,351
General-duty citation text
29 CFR 1926.502(a)(2): Employers shall provide and install all fall protection systems required by this subpart for an employee, and shall comply with all other pertinent requirements of this subpart before that employee begins the work that necessitates the fall protection. (A) Guardrail systems; (B) Safety net systems; or (C) Personal fall protection systems, such as personal fall arrest, travel restraint, or positioning systems. (a) On October 17, 2022, located on a commercial roof, employees were exposed to a fall hazard working near the edge of a low slope pitch roof not utilizing a fall protection system, and the employer failed to install a fall protection system before employees performed the work. The potential fall height was measured to be 9' with a roof pitch of 4/12.
Recent events (1)
- — Z (S) $4351
More inspections in this industry (NAICS 238160)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346286180.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.