Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: HERMS CONSTRUCTION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of HERMS CONSTRUCTION in 861 HARTMAN CIRCLE, HUDSON, WI 54016 (NAICS 238130). OSHA activity number 346381809.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Herms Construction — free Get an email when a new federal OSHA severe-injury report for Herms Construction is published. One employer, no account, unsubscribe in one click.
Establishment
HERMS CONSTRUCTION
Site address
861 HARTMAN CIRCLE
City
HUDSON
State
WI
ZIP
54016
Mailing
2817 POLK-ST. CROIX ROAD, CLEAR LAKE, WI 54005
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
2
Ownership type
A

5 citations on file for this inspection.

1926.453 B02 IV

Deleted Serious Gravity 10 1 instance 1 exposed
Issued
Dec 23, 2022
Abate by
Jan 10, 2023
Penalty
Initial $4,351 · Current $0 Reduced
29 CFR  1926.453(b)(2)(iv): Employee(s) were not standing firmly on the floor of the basket, were sitting or climbing on the edge of the basket, or were using planks, ladders, or other devices for a work position:  (a) North side of commercial building; A worker using a Genie model S-45 extensible boom lift, serial no. S4506-11032, to egress the roof was standing outside of the basket while holding onto the guardrail as the basket was lowered from an approximate height of 17-feet above ground level.
Recent events (3)
  • — F (S) $0
  • — C (S) $4351
  • — Z (S) $4351

1926.453 B02 V

Deleted Serious Gravity 10 1 instance 2 exposed
Issued
Dec 23, 2022
Abate by
Jan 10, 2023
Penalty
Initial $0 · Current $0
29 CFR 1926.453(b)(2)(v): A body belt with lanyard attached to the boom or basket was not worn by employee(s) working from an aerial lift:  (a) Commercial building, various locations; Workers used a Genie model S-45 extensible boom lift, serial no. S4506-11032, to access and egress the roof and/or perform framing work at an approximate height of 17-feet above ground level without the use of personal fall protection.
Recent events (3)
  • — F (S) $0
  • — C (S) $0
  • — Z (S) $0

1926.453 B02 VI

Deleted Serious Gravity 1 1 instance 2 exposed
Issued
Dec 23, 2022
Abate by
Jan 10, 2023
Penalty
Initial $1,865 · Current $0 Reduced
29 CFR 1926.453(b)(2)(vi): Boom and basket load limits specified by the manufacturer were exceeded:  (a) Commercial building, various locations; A Genie model S-45, serial no. S4506-11032 extensible boom lift was used in excess of the occupant/load capacity of two persons/500 lbs. as three workers occupied the basket while using the lift to access and/or egress the roof.
Recent events (3)
  • — F (S) $0
  • — C (S) $1865
  • — Z (S) $1865

1926.501 B10

Deleted Serious Gravity 10 1 instance 2 exposed
Issued
Dec 23, 2022
Abate by
Jan 10, 2023
Penalty
Initial $4,351 · Current $0 Reduced
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.  Or, on roofs 50-feet (15.25 m) or less in width, each employee was not protected by use of a monitoring system:  (a) Commercial roof structure, various locations; Workers installing steel roof panels from a low-slope roof were not protected from falls while working at approximate heights ranging between 17-feet to 29-feet, 3-inches above ground level.
Recent events (3)
  • — F (S) $0
  • — C (S) $4351
  • — Z (S) $4351

1926.503 A01

Deleted Serious Gravity 10 1 instance 2 exposed
Issued
Dec 23, 2022
Abate by
Jan 10, 2023
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  (a)  Commercial roof structure, various locations; Workers exposed to fall hazards at heights ranging between approximately 17-feet to 29-feet, 3-inches above ground level were not trained on fall hazard recognition and mitigation methods.
Recent events (3)
  • — F (S) $0
  • — C (S) $0
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346381809.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.