OSHA Inspection: DIGICO IMAGING INC.

Issued

Apr 7, 2023

Abate by

Apr 19, 2023

Penalty

Initial $7,813 · Current $4,688 Reduced

General-duty citation text

29 CFR  1910.213(c)(1):Each circular hand-fed ripsaw shall be guarded by a hood which shall completely enclose that portion of the saw above the table and that portion of the saw above the material being cut. The hood and mounting shall be arranged so that the hood will automatically adjust itself to the thickness of and remain in contact with the material being cut but it shall not offer any considerable resistance to insertion of material to saw or to passage of the material being sawed. The hood shall be made of adequate strength to resist blows and strains incidental to reasonable operation, adjusting, and handling, and shall be so designed as to protect the operator from flying splinters and broken saw teeth. It shall be made of material that is soft enough so that it will be unlikely to cause tooth breakage. The hood shall be so mounted as to insure that its operation will be positive, reliable, and in true alignment with the saw; and the mounting shall be adequate in strength to resist any reasonable side thrust or other force tending to throw it out of line.  a. On or about February 8, 2023, on the General International table saw, guards were not in place to prevent employees from coming into contact with the blade while ripping wood boards in the 3D shop.

Issued

Apr 7, 2023

Abate by

Apr 19, 2023

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR  1910.213(c)(2): Each hand-fed circular ripsaw shall be furnished with a spreader to prevent material from squeezing the saw or being thrown back on the operator. The spreader shall be made of hard tempered steel, or its equivalent, and shall be thinner than the saw kerf. It shall be of sufficient width to provide adequate stiffness or rigidity to resist any reasonable side thrust or blow tending to bend or throw it out of position. The spreader shall be attached so that it will remain in true alignment with the saw even when either the saw or table is tilted. The provision of a spreader in connection with grooving, dadoing, or rabbeting is not required. On the completion of such operations, the spreader shall be immediately replaced.   a. On or about February 8, 2023, on the General International table saw, a spreader was not in place to prevent material from squeezing the saw blade and causing material to be thrown back toward the operator while ripping wood boards in the 3D shop.

Issued

Apr 7, 2023

Abate by

Apr 19, 2023

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR  1910.213(c)(3): Each hand-fed circular ripsaw shall be provided with non-kickback fingers or dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator. They shall be designed to provide adequate holding power for all the thicknesses of materials being cut.   a. On or about February 8, 2023, on the General International table saw, non-kickback fingers or dogs were not in place to prevent material from being picked up and/or thrown back toward the operator while ripping wood boards in the 3D shop.

Issued

Apr 7, 2023

Penalty

Initial $7,813 · Current $4,688 Reduced

General-duty citation text

29 CFR  1904.39(a)(2):Basic Requirement. Within twenty-four (24) hours after the in-patient hospitalization of one or more employees or an employee's amputation or an employee's loss of an eye, as a result of a work-related incident, you must report the in-patient hospitalization, amputation, or loss of an eye to OSHA.  a. The employer did not report an in-patient hospitalization within 24 hours of being aware of the hospitalization. On or about February 8, 2023, an employee was hospitalized for 2 days after their finger was severely cut on a table saw that resulted in a surgical amputation.