NEENAH, WI —
OSHA Inspection: FEDEWA INC.
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of FEDEWA INC. in 333 W. CECIL ST., NEENAH, WI 54956 (NAICS 238320). OSHA activity number 346902141.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- FEDEWA INC.
- Site address
- 333 W. CECIL ST.
- City
- NEENAH
- State
- WI
- ZIP
- 54956
- Mailing
- 4315 E. M-79, HASTINGS, MI 49058
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238320
- Employees
- 11
- Ownership type
- A
Citations
6 citations on file for this inspection.
1910.134 E01
- Issued
- Oct 23, 2023
- Abate by
- Dec 1, 2023
- Penalty
- Initial $3,795 · Current $2,657 Reduced
General-duty citation text
29 CFR 1910.134(e)(1): The employer shall provide a medical evaluation to determine the employee's ability to use a respirator, before the employee is fit tested or required to use the respirator in the workplace. The employer may discontinue an employee's medical evaluations when the employee is no longer required to use a respirator: (Construction Reference 1926.103) On August 10, 2023, at a worksite located at 333 W. Cecil Ave. in Neenah, WI; the employer did not provide medical evaluations to determine employees' ability to use abrasive blasting helmet respirators which they used during abrasive blasting on the inside of a water tower tank.
Recent events (2)
- — I (S) $2656.5
- — Z (S) $3795
1910.134 I07
- Issued
- Oct 23, 2023
- Abate by
- Nov 21, 2023
- Penalty
- Initial $0 · Current $0
0560
General-duty citation text
29 CFR 1910.134(i)(7): For oil-lubricated compressors, the employer shall use a high-temperature or carbon monoxide alarm, or both, to monitor carbon monoxide levels. If only high-temperature alarms are used, the air supply shall be monitored at intervals sufficient to prevent carbon monoxide in the breathing air from exceeding 10 ppm: (Construction Reference 1926.103) On August 10, 2023, at a worksite located at 333 W. Cecil Ave. in Neenah, WI; employees wore abrasive blasting helmet respirators which were provided breathing air by an oil-lubricated Sullair compressor (Model 1600 HAF CAT). The employer did not have an integrated carbon monoxide alarm and was not monitoring breathing air for carbon monoxide while employees wore the respirators during abrasive blasting on the inside of a water tower tank.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.307 D01
- Issued
- Oct 23, 2023
- Abate by
- Nov 21, 2023
- Penalty
- Initial $3,795 · Current $2,657 Reduced
General-duty citation text
29 CFR 1926.307(d)(1): Pulleys, any parts of which are 7 feet (2.128 m) or less from the floor or working platform, shall be guarded in accordance with the standards specified in paragraphs (m) and (o) of this section: On August 10, 2023, at a worksite located at 333 W. Cecil Ave. in Neenah, WI; pullies on the motor of the dust collector equipment were less than 7 feet from the floor and were not guarded to prevent employees from entanglement hazards.
Recent events (2)
- — I (S) $2656.5
- — Z (S) $3795
1926.307 E03 I
- Issued
- Oct 23, 2023
- Abate by
- Nov 21, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.307(e)(3)(i): Vertical and inclined belts shall be enclosed by a guard conforming to standards in paragraphs (m) and (o) of this section: On August 10, 2023, at a worksite located at 333 W. Cecil Ave. in Neenah, WI; inclined belts on the motor of the dust collector equipment were not guarded to protect employees from entanglement and ingoing nip point hazards.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.501 B04 I
- Issued
- Oct 23, 2023
- Penalty
- Initial $3,036 · Current $2,125 Reduced
General-duty citation text
29 CFR 1926.501(b)(4)(i): Each employee on walking/working surfaces shall be protected from falling through holes (including skylights) more than 6 feet (1.8 m) above lower levels, by personal fall arrest systems, covers, or guardrail systems erected around such holes. On August 10, 2023, at a worksite located at 333 W. Cecil Ave. in Neenah, WI; employees conducting abrasive blasting inside in the water tower were not protected from falling through a hole in the walking/working surface of the water tower.
Recent events (2)
- — I (S) $2125.2
- — Z (S) $3036
1926.503 B01
- Issued
- Oct 23, 2023
- Abate by
- Nov 21, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(b)(1): The employer shall verify compliance with paragraph (a) of this section by preparing a written certification record. The written certification record shall contain the name or other identity of the employee trained, the date(s) of the training, and the signature of the person who conducted the training or the signature of the employer. If the employer relies on training conducted by another employer or completed prior to the effective date of this section, the certification record shall indicate the date the employer determined the prior training was adequate rather than the date of actual training: On August 10, 2023, at a worksite located at 333 W. Cecil Ave. in Neenah, WI; the employer did not verify through written certification that employees had been provided training to recognize fall hazards and the procedures to minimize falls as described in paragraph (a) of this section. The employer did not certify that employees who were exposed to fall hazards while working from elevated platforms, climbing fixed ladders and walking/working on surfaces with holes, had been trained.
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections at Fedewa INC.
View Fedewa INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238320)
More inspections in WI
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346902141.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.