Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: GILBERTO SABINO

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of GILBERTO SABINO in 144 CLAY WOOD DRIVE, GLENN HEIGHTS, TX 75154 (NAICS 238160). OSHA activity number 347288458.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Gilberto Sabino — free Get an email when a new federal OSHA severe-injury report for Gilberto Sabino is published. One employer, no account, unsubscribe in one click.
Establishment
GILBERTO SABINO
Site address
144 CLAY WOOD DRIVE
City
GLENN HEIGHTS
State
TX
ZIP
75154
Mailing
6812 FRANWOOD TERRACE, FORT WORTH, TX 76112
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Last modified
Data loaded
NAICS code
238160
Employees
6
Ownership type
A

5 citations on file for this inspection.

1926.102 A01

Serious Gravity 1 1 instance 6 exposed
Issued
Feb 16, 2024
Abate by
Mar 18, 2024
Penalty
Initial $2,074 · Current $2,074
29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical, chemical, or radiation agents.  At the jobsite, employees operating a Porta cable nail gun to perform roofing activities without eye and face protection exposing him to the hazard of being struck-by flying objects.
Recent events (1)
  • — Z (S) $2074

1926.501 B10

Serious Gravity 10 1 instance 6 exposed
Issued
Feb 16, 2024
Abate by
Mar 18, 2024
Penalty
Initial $4,839 · Current $4,839
29 CFR  1926.501(b)(10): "Roofing work on Low-slope roofs." Except as otherwise provided in paragraph (b) of this section, each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.    At the jobsite, employees installing roofing shingles were observed wearing fall protection but were not tied off, exposing employees to unprotected fall hazard at a height of over 6 feet to the ground below.
Recent events (1)
  • — Z (S) $4839

1926.1053 B01

Serious Gravity 5 1 instance 6 exposed
Issued
Feb 16, 2024
Abate by
Mar 18, 2024
Penalty
Initial $2,765 · Current $2,765
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access;    At the jobsite, Employees engaged in installing roofing material, were exposed to fall hazards while using a ladder that did not extend at least three feet above the roof's landing.
Recent events (1)
  • — Z (S) $2765

1926.503 A01

Other-than-serious 1 instance 6 exposed
Issued
Feb 16, 2024
Abate by
Mar 18, 2024
Penalty
Initial $388 · Current $388
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  At the jobsite, employees performing roofing activities were provided fall protection but was not tied off.  The employer did not provide a training program with hazard recognition and avoidance training where part of the job is to be exposed to fall hazards at a heights over 6 feet to the ground below.
Recent events (1)
  • — Z (O) $388

1926.1060 A

Other-than-serious 1 instance 6 exposed
Issued
Feb 16, 2024
Abate by
Mar 18, 2024
Penalty
Initial $0 · Current $0
29 CFR  1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards.    At the jobsite, Employees engaged in installing roofing material, were not provided training on how to recognize and avoid ladder hazards and fall hazards while using ladders.
Recent events (1)
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347288458.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.