Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: OUTERLAND HOLDINGS, LLC

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of OUTERLAND HOLDINGS, LLC in 150 GLENEAGLE DRIVE, MASHPEE, MA 02649 (NAICS 561730). OSHA activity number 347481921.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Outerland Holdings, LLC — free Get an email when a new federal OSHA severe-injury report for Outerland Holdings, LLC is published. One employer, no account, unsubscribe in one click.
Site address
150 GLENEAGLE DRIVE
City
MASHPEE
State
MA
ZIP
02649
Mailing
28 NICOLETTAS WAY, MASHPEE, MA 02649
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
561730
Employees
80
Ownership type
A

4 citations on file for this inspection.

5(a)(1)

Serious Gravity 5 1 instance 1 exposed
Issued
Sep 20, 2024
Abate by
Oct 21, 2024
Penalty
Initial $9,680 · Current $4,000 Reduced
OSH ACT of 1970 Section (5)(a)(1):The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to laceration hazards due to employees using grinders one handed and without the aid of the auxiliary handle.  Location: 150 Gleneagle Drive, Mashpee MA Backyard area  On or about May 15, 2024, employees were exposed to serious bodily injury while using a grinder without a side handle as described by ANSI B7.1 2010 as well as the procedures outlined in the operator's manual.
Recent events (2)
  • — I (S) $4000
  • — Z (S) $9680

1926.1153 C01

Serious Gravity 10 1 instance 12 exposed
Issued
Sep 20, 2024
Abate by
Oct 21, 2024
Penalty
Initial $11,292 · Current $6,000 Reduced
29 CFR  1926.1153(c)(1): For each employee engaged in a task identified on Table 1, the employer did not fully and properly implement the engineering controls, work practices, and respiratory protection specified for the task on Table 1.  Location: 150 Gleneagle Drive, Mashpee MA Backyard area  On or about May 15, 2024, employees were exposed to health hazards associated to respirable crystalline silica by not implementing engineering controls outlined in Table 1 of this OSHA standard.  Employees were required to cut and grind veneer stone, the employer did not fully implement the required engineering controls, work practices, and respiratory protection specified for the task of "Handheld grinders for uses other than mortar removal" as outlined on Table 1, "Equipment/task (xii)" outlined in 29 CFR 1926.1153.  Employees were exposed to respirable crystalline silica while using a grinder not equipped with a dust collection system to manage dust control. These controls are required because the employer did not conduct an employee exposure assessment in accordance with paragraph (d) of this section to determine if workers were overexposed to crystalline silica.
Recent events (2)
  • — I (S) $6000
  • — Z (S) $11292

1926.1153 E01

Serious Gravity 5 1 instance 12 exposed
Issued
Sep 20, 2024
Abate by
Oct 21, 2024
Penalty
Initial $8,067 · Current $0 Reduced
29 CFR  1926.1153(e)(1):Where respiratory protection was required by this section, the employer did not provide each employee an appropriate respirator that complied with the requirements of this paragraph and 29 CFR 1910.134:  Location: 150 Gleneagle Drive, Mashpee MA Backyard area  On or about May 15, 2024, workers were required to cut and grind veneer stone.  When the employer did not use adequate measures to control the silica-containing dust, not all employees were provided with an appropriate respirator that complied with the requirements of 29 CFR 1910.134.  Worker wore a disposable dust mask that was not effective against silica-containing dusts above the PEL.
Recent events (2)
  • — I (S) $0
  • — Z (S) $8067

1926.1153 E02

Other-than-serious Gravity 1 1 instance 12 exposed
Issued
Sep 20, 2024
Abate by
Oct 21, 2024
Penalty
Initial $4,839 · Current $0 Reduced
29 CFR  1926.1153(e)(2):Where respirator use is required by this section, the employer did not institute a respiratory protection program in accordance with 29 CFR 1910.134:  Location: 150 Gleneagle Drive, Mashpee MA Backyard area  On or about May 15, 2024, when employees wore half-face elastomeric respirators as protection against silica-containing concrete dust, the employer did not institute a written respirator program in accordance with 29 CFR 1910.134.
Recent events (2)
  • — I (O) $0
  • — Z (S) $4839

View Outerland Holdings, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347481921.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.