Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: LISANDRO LOZANO ZUNIGA

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of LISANDRO LOZANO ZUNIGA in 324 PASTURE DRIVE, MIDLOTHIAN, TX 76065 (NAICS 238130). OSHA activity number 347507287.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Lisandro Lozano Zuniga — free Get an email when a new federal OSHA severe-injury report for Lisandro Lozano Zuniga is published. One employer, no account, unsubscribe in one click.
Site address
324 PASTURE DRIVE
City
MIDLOTHIAN
State
TX
ZIP
76065
Mailing
4524 HAMPSHIRE BLVD, FORT WORTH, TX 76103
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

6 citations on file for this inspection.

1926.100 A

Serious Gravity 1 1 instance 5 exposed
Issued
May 24, 2024
Abate by
Jun 25, 2024
Penalty
Initial $2,074 · Current $2,074
29 CFR 1926.100(a): Employees were not protected by protective helmets while working in areas where there was a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns.  At the construction site, the employer did not ensure that employees were wearing hardhats while working below other employees. Employees were exposed to a struck-by hazard from falling objects.
Recent events (1)
  • — Z (S) $2074

1926.102 A01

Serious Gravity 1 1 instance 6 exposed
Issued
May 24, 2024
Abate by
Jun 25, 2024
Penalty
Initial $2,074 · Current $2,074
29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical, chemical, or radiation agents.  At the jobsite, employees operating a Pneutools nail gun to perform framing activities without eye and face protection exposing him to the hazard of being struck-by flying objects.
Recent events (1)
  • — Z (S) $2074

1926.501 B13

Serious Gravity 5 1 instance 5 exposed
Issued
May 24, 2024
Abate by
Jun 25, 2024
Penalty
Initial $3,457 · Current $3,457
29 CFR 1926.501(b)(13):  Each employee engaged in residential construction activities 6 feet or more above lower levels was not protected by guardrail systems, safety net systems, or personal fall arrest system.  At the jobsite, employees installing framing activities were not provided fall protection and exposed to an unprotected fall hazard at a height of over 6 feet to the ground below.
Recent events (1)
  • — Z (S) $3457

1926.1051 A

Serious Gravity 1 1 instance 5 exposed
Issued
May 24, 2024
Abate by
Jun 25, 2024
Penalty
Initial $2,074 · Current $2,074
29 CFR  1926.1051(a): Stairway(s) or ladder(s) were not provided at all personnel points of access where there was a break in elevation of 19 inches (48 cm) or more, or no ramp, runway, sloped embankment, or personnel hoist was provided.  At  the construction site, the employer did not provide an extension ladder for employees to access and egress the upper levels of the residential structure, exposing  employees to a fall hazard.
Recent events (1)
  • — Z (S) $2074

1926.503 A01

Other-than-serious 1 instance 5 exposed
Issued
May 24, 2024
Abate by
Jun 25, 2024
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  At the jobsite, employees performing framing activities were not provided fall protection.  The employer did not provide a training program with hazard recognition and avoidance training where part of the job is to be exposed to fall hazards at a heights over 6 feet to the ground below.
Recent events (1)
  • — Z (O) $0

1926.1060 A

Other-than-serious 1 instance 5 exposed
Issued
May 24, 2024
Abate by
Jun 25, 2024
Penalty
Initial $0 · Current $0
29 CFR 1926.1060(a): The employer shall provide a training program for each employee using ladders and stairways, as necessary. The program shall enable each employee to recognize hazards related to ladders and stairways, and shall train each employee in the procedures to be followed to minimize these hazards.   At the residential construction site, the employer did not ensure employees installing framing material were trained to recognize and avoid slip and fall hazards related to ladders.
Recent events (1)
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347507287.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.