RICE LAKE, WI —
OSHA Inspection: J RODRIGUEZ REMODELING LLC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of J RODRIGUEZ REMODELING LLC in 123 W KNAPP ST., RICE LAKE, WI 54868 (NAICS 238160). OSHA activity number 347535288.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- J RODRIGUEZ REMODELING LLC
- Site address
- 123 W KNAPP ST.
- City
- RICE LAKE
- State
- WI
- ZIP
- 54868
- Mailing
- 1114 BUSH AVE., APT 2, SAINT PAUL, MN 55106
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 8
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.102 A01
- Issued
- Sep 13, 2024
- Abate by
- Sep 27, 2024
- Penalty
- Initial $2,074 · Current $2,074
General-duty citation text
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation: (a) Roof of residential home; On or about June 5, 2024, employees were allowed to operate pneumatic nail guns during roofing activities without wearing eye protection.
Recent events (1)
- — Z (S) $2074
1926.501 B13
- Issued
- Sep 13, 2024
- Abate by
- Sep 27, 2024
- Penalty
- Initial $4,839 · Current $4,839
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): (a) Roof of residential home; On or about June 5, 2024, fall protection systems were not used during residential reroofing operations at heights ranging from 10 feet, 6 inches to more than 25 feet above the ground.
Recent events (1)
- — Z (S) $4839
1926.503 A01
- Issued
- Sep 13, 2024
- Abate by
- Sep 27, 2024
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: (a) Roof of residential home; On or about June 5, 2024, and dates prior, fall hazard awareness and/or fall prevention training was not provided to employees before they performed roofing activities at heights ranging from 10 feet, 6 inches to more than 25 feet above the ground.
Recent events (1)
- — Z (S) $0
1926.1053 B01
- Issued
- Sep 13, 2024
- Abate by
- Sep 27, 2024
- Penalty
- Initial $3,457 · Current $3,457
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: (a) Roof of residential home; On or about June 5, 2024, side rails of aluminum extension ladder setup at ground level to access an elevated work area on the lower back roof did not extend 3 feet past the upper landing. (b) Roof of residential home; On or about June 5, 2024, side rails of aluminum extension ladder setup on the lower back roof to access an elevated work area on the upper main roof did not extend 3 feet past the upper landing. (c) Roof of residential home; On or about June 5, 2024, side rails of an aluminum multi-ladder setup as a non-self-supporting ladder to access an elevated work area on the front porch roof did not extend 3 feet past the upper landing.
Recent events (1)
- — Z (S) $3457
1926.1060 A
- Issued
- Sep 13, 2024
- Abate by
- Sep 27, 2024
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would train each employee in the procedures to be followed to minimize hazards related to ladders and stairways: (a) Roof of residential home; On or about June 5, 2024, training was not provided to inform employees how to properly setup, use, and inspect ladders before they used extension and multi-position type ladders to access elevated work areas as part of roofing operations.
Recent events (1)
- — Z (S) $0
More inspections in this industry (NAICS 238160)
More inspections in WI
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347535288.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.