MONROE, OH —
OSHA Inspection: ISIDRO FRAMING LLC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of ISIDRO FRAMING LLC in 920 MORGAN DR, MONROE, OH 45050 (NAICS 238130). OSHA activity number 347795171.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ISIDRO FRAMING LLC
- Site address
- 920 MORGAN DR
- City
- MONROE
- State
- OH
- ZIP
- 45050
- Mailing
- 7748 JOAN DR, WEST CHESTER, OH 45069
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 6
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.20 B02
- Issued
- Oct 22, 2024
- Penalty
- Initial $4,839 · Current $2,420 Reduced
General-duty citation text
29 CFR 1926.20(b)(2): Accident prevention responsibilities. Such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers. a) On or about October 3, 2024, the employer did not conduct adequate inspections of the job site. As a result, employees were exposed to fall heights greater than 11 ft in that fall protection was not being utilized while performing framing work and the ladder was not extended 3 ft above the access point on the roof.
Recent events (2)
- — I (S) $2419.5
- — Z (S) $4839
1926.501 B13
- Issued
- Oct 22, 2024
- Penalty
- Initial $4,839 · Current $0 Reduced
General-duty citation text
29 CFR 1926.501(b)(13):"Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems. a) On or before October 3, 2024, the employer failed to ensure that employees performing framing on a residential home were utilizing a fall protection system. As a result, employees were exposed to fall heights greater than 11 ft.
Recent events (2)
- — I (S) $0
- — Z (S) $4839
1926.1053 B01
- Issued
- Oct 22, 2024
- Penalty
- Initial $4,148 · Current $0 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1):When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a guardrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support. a) On or about October 3, 2024, the employer did not ensure that employees exposed to a fall hazard were protected in that the portable ladder used for accessing the roof only extended 1 ft above the upper landing surface.
Recent events (2)
- — I (S) $0
- — Z (S) $4148
1926.503 A01
- Issued
- Oct 22, 2024
- Abate by
- Dec 10, 2024
- Penalty
- Initial $4,839 · Current $2,420 Reduced
General-duty citation text
29 CFR 1926.503(a)(1):The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. a) On or about October 3, 2024, the employer failed to ensure that each employee exposed to a fall hazard was trained on the hazards of falling and the procedures to minimize the hazards in the work area. As a result, employees were exposed to fall hazards greater than 11 feet while performing residential framing work.
Recent events (2)
- — I (S) $2419.5
- — Z (S) $4839
More inspections in this industry (NAICS 238130)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347795171.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.