OSHA Inspection: SCAN TOOL & MOLD INC.

Issued

2024-12-18 00:00:00

Abate by

2025-01-15 00:00:00

Penalty

Initial $2765.00 · Current $1383.00 Reduced

General-duty citation text

29 CFR1910.101(b): The in-plant handling, storage, and utilization of all compressed gases in cylinders, portable tanks, rail tankcars, or motor vehicle cargo tanks were not in accordance with Compressed Gas Association Pamphlet P-1-1965, which is incorporated by reference as specified in CFR 1910.6.  Location: 2 Trefoil Drive Trumbull, CT 06611  On or about November 22, 2024, the employer did not ensure (2) compressed gas cylinders containing nitrogen gas were secured from being knocked over. (REFERENCE CGA P-1-1965 SECTION 3.3.1)

Issued

2024-12-18 00:00:00

Abate by

2025-02-06 00:00:00

Penalty

Initial $5531.00 · Current $2766.00 Reduced

General-duty citation text

29 CFR1910.147(c)(1): The employer did not establish a program consisting of energy control procedures, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source(s) and rendered inoperative.  Location: 2 Trefoil Drive Trumbull, CT 06611  On or about November 22, 2024, the employer did not establish hazardous energy control lockout/tagout program for the employees on the machinery such as but not limited to the Arburg and Engel injection molding machines.

Issued

2024-12-18 00:00:00

Abate by

2025-02-06 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section.  Location: 2 Trefoil Drive Trumbull, CT 06611  On or about November 22, 2024, the employer did not establish hazardous energy control lockout/tagout procedures for the employees on the machinery such as but not limited to the Arburg and Engel injection molding machines.

Issued

2024-12-18 00:00:00

Abate by

2025-02-06 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.147(c)(7)(i): The employer did not provide adequate training to ensure that the purpose and function of the energy control program was understood by employees, and that the knowledge and skills required for the safe application, usage, and removal of the energy controls were acquired by employees.  Location: 2 Trefoil Drive Trumbull, CT 06611  On or about November 22, 2024, the employer did not provide hazardous energy control lockout/tagout training for the affected employees on machinery such as but not limited to Arburg and Engel injection molding machines.