STREETSBORO, OH ·
OSHA Inspection: STREETSBORO OPCO LLC
Planned inspection · Health discipline
At a glance
On , OSHA opened a planned health inspection of STREETSBORO OPCO LLC in 1645 MAPLEWOOD DRIVE, STREETSBORO, OH 44241 (NAICS 623110). OSHA activity number 348019688.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- STREETSBORO OPCO LLC
- Site address
- 1645 MAPLEWOOD DRIVE
- City
- STREETSBORO
- State
- OH
- ZIP
- 44241
- Mailing
- 1645 MAPLEWOOD DRIVE, STREETSBORO, OH 44241
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Health
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 623110
- Employees
- 70
- Ownership type
- Private (A)
Citations
5 citations on file for this inspection.
1910.1030 C01 V
- Issued
- May 28, 2025
- Abate by
- Jun 24, 2025
- Penalty
- Initial $11,585 · Current $5,792 Reduced
General-duty citation text
29 CFR 1910.1030(c)(1)(v): The employer, who is required to establish an Exposure Control Plan, did not solicit input from non-managerial employees responsible for direct patient care who are potentially exposed to injuries from contaminated sharps in the identification, evaluation and selection of effective engineering and work practice controls and did not document the solicitation in the Exposure Control plan. On and about February 4, 2025, the employer did not solicit input from non-managerial employees in identification, evaluation, and selection of effective engineering and work practice controls.
Recent events (2)
- · I (S) $5792
- · Z (S) $11585
1910.1030 D02 I
- Issued
- May 28, 2025
- Abate by
- Jun 24, 2025
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.1030(d)(2)(i): Engineering and work practice controls were not used to eliminate or minimize employees exposure. On and about February 4, 2025, sharps including but not limited to syringes and needles were utilized that did not contain safety engineering controls.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1910.1030 D04 III A2III
- Issued
- May 28, 2025
- Abate by
- Jun 24, 2025
- Penalty
- Initial $11,585 · Current $5,792 Reduced
General-duty citation text
29 CFR 1910.1030(d)(4)(iii)(A)(2)(iii): During use, containers for contaminated sharps were not replaced routinely or were allowed to be overfill. a) On or about February 4, 2025, the employer exposed employees to potential needlesticks by having employees place used sharps into a full sharps container that was on the nurses cart located near room 106. b) On or about February 4, 2025, the employer exposed employees to potential needlesticks by having employees place used sharps/razors into a full sharps container located in the shower room. c) On or about February 4, 2025, the employer exposed employees to potential needlesticks by having employees place used sharps into a full sharps container that was on the nurses cart located near room 604.
Recent events (2)
- · I (S) $5792
- · Z (S) $11585
1910.1030 G02 IV
- Issued
- May 28, 2025
- Abate by
- Jun 24, 2025
- Penalty
- Initial $8,276 · Current $4,138 Reduced
General-duty citation text
29 CFR 1910.1030(g)(2)(iv): Annual training for all employees shall be provided within one year of their previous training. On or about February 4, 2025, the employer did not provide annual bloodborne pathogen training to employees.
Recent events (2)
- · I (S) $4138
- · Z (S) $8276
1910.303 G01 I
- Issued
- May 28, 2025
- Abate by
- Jun 24, 2025
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.303(g)(1)(i): Work space was less than 30 inches wide in front of electric equipment operating at 600 volts, nominal, or less: a) On or about June 4, 2025, the circuit breaker panel that was located in the breakroom did not have at least three feet of access and working space in front of the panels, exposing employees to an arc flash hazard. b) On or about June 4, 2025, the electrical disconnect panel labeled HVAC 11 and 12 did not have at least three feet of access and working space in front of the panel, exposing employees to an arc flash hazard.
Recent events (2)
- · I (O) $0
- · Z (O) $0
More inspections in this industry (NAICS 623110)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 348019688.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.