Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: RIVERSIDE SERVICES LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of RIVERSIDE SERVICES LLC in 608 TOWN PARK LOOP, RINCON, GA 31326 (NAICS 238120). OSHA activity number 348043738.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Riverside Services LLC — free Get an email when a new federal OSHA severe-injury report for Riverside Services LLC is published. One employer, no account, unsubscribe in one click.
Site address
608 TOWN PARK LOOP
City
RINCON
State
GA
ZIP
31326
Mailing
1700 NIXON CHAPEL RD, SPRINGFIELD, GA 31329
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238120
Employees
5
Ownership type
A

9 citations on file for this inspection.

1926.100 A

Serious Gravity 5 1 instance 4 exposed
Issued
Jun 6, 2025
Penalty
Initial $2,837 · Current $1,702 Reduced
29 CFR  1926.100(a): Employees were not protected by protective helmets while working in areas where there was a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns:   (a) Backside of the building - On or about February 12, 2025, the employer exposed employees and subcontractor employees to a struck-by hazard, in that head protection was not worn where overhead work was performed.
Recent events (2)
  • — I (S) $1702.2
  • — Z (S) $2837

1926.451 E08

Serious Gravity 5 1 instance 1 exposed
Issued
Jun 6, 2025
Abate by
Jun 18, 2025
Penalty
Initial $2,837 · Current $1,702 Reduced
29 CFR  1926.451(e)(8):Direct access to or from another surface was used when the scaffold was more than 14 inches (36 cm) horizontally and/or 24 inches (61 cm) vertically from the other surface:  (a)   Backside of the building - On or about February 12, 2025, the employer exposed employees to a fall hazard, in that an employee directly accessed an elevated personnel basket that was more than 14 inches (36 cm) horizontally and/or 24 inches from the building frame.
Recent events (2)
  • — I (S) $1702.2
  • — Z (S) $2837

1926.454 A

Serious Gravity 5 1 instance 2 exposed
Issued
Jun 6, 2025
Abate by
Jul 25, 2025
Penalty
Initial $0 · Current $0
29 CFR  1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.   (a )   Backside of the building - On or about February 12, 2025, the employer exposed employees to a fall hazard, in that employees were not trained to recognize and the procedures to control or minimize scaffold hazards.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.602 C01 VI

Serious Gravity 5 1 instance 4 exposed
Issued
Jun 6, 2025
Abate by
Jun 18, 2025
Penalty
Initial $3,547 · Current $2,128 Reduced
29 CFR  1926.602(c)(1)(vi): Industrial truck(s) in use did not meet the applicable requirements of design, construction, stability, inspection, testing, maintenance, and operation, as defined in American National Standards Institute B56.1-1969, Safety Standards for Powered Industrial Trucks.   (a) Backside of the building - On or about February 12, 2025, the employer exposed employees and subcontractor employees to a struck-by hazard, in that the employer did not ensure employees and subcontractor employees did not stand under the suspended load of a forklift.
Recent events (2)
  • — I (S) $2128.2
  • — Z (S) $3547

1926.760 A01

Serious Gravity 10 1 instance 2 exposed
Issued
Jun 6, 2025
Abate by
Jul 3, 2025
Penalty
Initial $4,965 · Current $2,979 Reduced
29 CFR  1926.760(a)(1):Each employee engaged in a steel erection activity who is on a walking/working surface with an unprotected side or edge more than 15 feet (4.6 m) above a lower level was not protected from fall hazards by guardrail systems, safety net systems, personal fall arrest systems, positioning device systems, or fall restraint systems:  (a) Backside of the building - On or about February 12, 2025, the employer exposed subcontractor employees to a fall hazard, in that fall protection was not worn while subcontractor employees connected the building frame with an approximately 17 ' fall to ground distance.
Recent events (2)
  • — I (S) $2979
  • — Z (S) $4965

1926.1053 B01

Serious Gravity 5 1 instance 1 exposed
Issued
Jun 6, 2025
Abate by
Jun 18, 2025
Penalty
Initial $3,547 · Current $2,128 Reduced
29 CFR  1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:  (a) Backside of the building - On or about February 12, 2025, the employer exposed subcontractor employees to a fall hazard, in that subcontractor employees used an extension ladder to access the building frame that did not have its side rails extended at least 3 feet above the upper landing surface.
Recent events (2)
  • — I (S) $2128.2
  • — Z (S) $3547

1926.1053 B13

Serious Gravity 5 1 instance 1 exposed
Issued
Jun 6, 2025
Penalty
Initial $0 · Current $0
29 CFR  1926.1053(b)(13):The top or top step of a stepladder was used as a step:  (a) Backside of the building - On or about February 12, 2025, the employer exposed employees to a fall hazard, in that an employee was allowed to sit on the top of a 10' step ladder to perform work.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1060 A01

Serious Gravity 5 2 instances 2 exposed
Issued
Jun 6, 2025
Abate by
Jul 25, 2025
Penalty
Initial $0 · Current $0
29 CFR  1926.1060(a)(1): The employer did not provide a training program for each employee using ladders as necessary, enabling each employee to recognize hazards related to ladders and the procedures to be followed to minimize these hazards.   (a)   Backside of the building - On or about February 12, 2025, the employer exposed employees to a fall hazard, in that employees and subcontractor employees were not trained in ladder safety.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.602 D

Other-than-serious 1 instance 5 exposed
Issued
Jun 6, 2025
Abate by
Jul 25, 2025
Penalty
Initial $0 · Current $0
29 CFR  1926.602(d):The employer did not certify that each operator had been trained and evaluated as required by paragraph 29 CFR 1910.178(l):Note: The requirements applicable to construction work under paragraph (d) of this section are identical to those set forth at paragraph (l) of 29 CFR 1910.178.   (a)   Back of the building and roof - On or about February 12, 2025, and times prior to, the employer exposed employees and subcontractor employees to a struck-by hazard, in that the employer did not ensure forklift operators were trained in accordance with 1910.178(l) prior to operation of a forklift.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 348043738.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.