OSHA Inspection: JEAN CARLOS JOVEL BUSTAMANTE

Issued

Jun 6, 2025

Penalty

Initial $4,256 · Current $1,702 Reduced

General-duty citation text

29 CFR  1926.102(a)(1): Employees did not use eye and face protection equipment when machines or operations presented potential eye or face injury from physical, chemical, or radiation agents:   (a) On or about 03/12/2025, at 1120 Sanie Cove Lane, Margaret AL, the employer did not ensure eye protection was used by employees operating pneumatic nailers exposing them to eye injuries.

Issued

Jun 6, 2025

Penalty

Initial $4,965 · Current $1,986 Reduced

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):   (a) On or about 03/12/2025, at 1120 Sanie Cove Lane, Margaret AL, the employer exposed an employee to fall hazards, in that fall protection was not utilized by employees performing framing activities at approximately 20.5 feet height.  (b) On or about 03/12/2025, at 1120 Sanie Cove Lane, Margaret AL, the employer exposed an employee to fall hazards, in that fall protection was not utilized by employees performing framing activities at approximately 10 feet- 4 inches height.

Issued

Jun 6, 2025

Abate by

Jun 26, 2025

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  (a) On or about 03/12/2025, at 1120 Sanie Cove Lane, Margaret AL,  the employer exposed employees to fall hazards, in that fall protection training was not provided to employees while performing framing activities at heights over 6 feet.  In accordance with 29 CFR 1903.19(d), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in addition, documentation demonstrating that abatement is complete must be included with your certification. This documentation may include, but is not limited to, evidence of the purchase or repair of the equipment, photographic or video evidence of abatement, or other written records.