OSHA Inspection: DELMARVA CORRUGATED PACKAGING, INC.

Issued

2025-05-06 00:00:00

Abate by

2025-06-02 00:00:00

Penalty

Initial $14895.00 · Current $10427.00 Reduced

General-duty citation text

OSH ACT of 1970 Section (5)(a)(1):The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees:  a) 1601 POW/MIA Parkway Dover Delaware 19904 (Macarbox line): On or about March 17, 2025, and days prior thereto,  employees were exposed to caught-in or nip point hazards when they performed maintenance operations that were not in accordance with ANSI B20.1-2000. Operations included, but were not limited to, maintenance and service of the Macarbox line conveyors that were not provided with  pre-start up warning devices, adequate visibility warning labels, and emergency stopping devices:

Issued

2025-05-06 00:00:00

Abate by

2025-06-02 00:00:00

Penalty

Initial $14895.00 · Current $10427.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(6)(ii): The employer did not certify that the periodic inspections have been performed:  a)	1601 POW/MIA Parkway Dover Delaware 19904 (Macarbox line): On or about March 17, 2025 one days prior, the employer failed to conduct periodic inspections and certify them to ensure that the developed energy control procedures clearly identified specific steps to be followed to control hazardous energy for equipment located on the Macarbox conveyor line on which employees perform set up, servicing, cleaning, and maintenance duties.  Abatement Note:  1 Where lockout should be used for energy control, the periodic inspection shall include a review, between the inspector and each authorized employee, of that employee's responsibilities under the energy control procedures being inspected. 1910.147(c)(6)(i)(D).  2. Where tagout should be used for energy control, the periodic inspection shall include a review, between the inspector and each authorized and affected employee, of that employee's responsibilities under the energy control procedure being inspected, and the elements set forth in paragraph (c)(7)(ii) this section. 1910.147(c)(6)(ii)  3. The employer shall certify that the periodic inspections have been performed. The certification shall identify the machine or equipment on which the energy control procedure was being utilized, the date of the inspection, the employees included in the inspection, and the person performing the inspection.

Issued

2025-05-06 00:00:00

Abate by

2025-06-02 00:00:00

Penalty

Initial $10641.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.147(d)(2): The machine or equipment was not turned off or shut down using the procedures established for the machine or equipment:  a) 1601 POW/MIA Parkway Dover Delaware 19904 (Macarbox line): On or about March 17, 2025, and days prior thereto, employees conducting service/maintenance were not protected from caught-in injuries as a result of not following the established lockout tagout procedure.