LIBERTY HILL, TEXAS—
Texas Steel Industrial Placing LLC
Struck by running powered equipment n.e.c. · Cuts, lacerations, punctures without injury to internal structures
Final narrative
An employee was preparing formwork for the next task. He cut a 2 x 4 with a circular saw and then placed the saw on the side of a wooden sawhorse. He then walked around the sawhorse and contacted the still-moving blade. The employee sustained a laceration above the knee.
Similar incidents · Same event type
EAST BERNARD, TEXAS—
T G Meat Center LLC
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
BOULDER, COLORADO—
Burke Builders Inc
An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.
NEW CANEY, TEXAS—
LMMM Houston #80, LTD.
An employee was using a meat saw to slice pork when the blade amputated their right little fingertip.
NORTH KINGSTOWN, RHODE ISLAND—
Electric Boat Corporation
An employee was struck by a plasma cutter and suffered a broken left tibia and fibula. The employee was hospitalized.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.