JORDAN, NY ·
OSHA Inspection: OMEGA WIRE, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of OMEGA WIRE, INC. in 24 NORTH BEAVER STREET, JORDAN, NY 13080 (NAICS 000000). OSHA activity number 302687710.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- OMEGA WIRE, INC.
- Site address
- 24 NORTH BEAVER STREET
- City
- JORDAN
- State
- NY
- ZIP
- 13080
- Mailing
- PO BOX 131, CAMDEN, NY 13316
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 3351
- Employees
- 251
- Ownership type
- Private (A)
- Industry flags
- Manufacturing safety.
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Oct 6, 1999
- Abate by
- Oct 12, 1999
- Penalty
- Initial $4,500 · Current $2,700 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of being struck by the load should the overhead hoist or below-the-hook lifting devices fail: a)Throughout the facility, on or about 06/11/99 through 06/19/99: Below the hook lifting devices had no rated load markings and no initial, frequent or periodic inspections performed, exposing employees to a struck by hazard. Among other methods, several feasible and acceptable abatement methods to correct each of these hazards are to: 1.Prior to initial use, all new, modified or repaired lifting devices shall be inspected by a designated person and an operational test performed to verify compliance. 2.Mark the rated load capacity of the lifting device on the main structure or equivalent. 3.Conduct frequent and periodic inspections of the lifting devices for wear, deterioration or malfunction in accordance with ASME B30.20. b)Throughout the facility, on or about 6/11/99 through 6/19/99: Overhead hoists had improperly adjusted limit switches and initial, frequent or periodic inspections had not been performed on the overhead hoists, exposing employees to a struck by hazard. Among other methods, several feasible and acceptable abatement methods to correct each of these hazards are to: 1.Adjust and/or repair upper limit switches to prevent the load block from passing the safe upper limit of travel. 2.Conduct frequent and periodic inspections of the overhead hoists in accordance with ASME B30.16.
Recent events (2)
- · I (S) $2700.00
- · Z (S) $4500.00
1910.147 C04 I
- Issued
- Oct 6, 1999
- Abate by
- Oct 12, 1999
- Penalty
- Initial $4,500 · Current $2,700 Reduced
Recent events (2)
- · I (S) $2700.00
- · Z (S) $4500.00
1910.147 C06 I
- Issued
- Oct 6, 1999
- Abate by
- Oct 12, 1999
Recent events (2)
- · I (S)
- · Z (S)
1910.151 C
- Issued
- Oct 6, 1999
- Abate by
- Oct 12, 1999
- Penalty
- Initial $1,350 · Current $810 Reduced
Recent events (2)
- · I (S) $810.00
- · Z (S) $1350.00
More inspections at Omega Wire, INC.
View Omega Wire, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 302687710.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.